วีดีโอ

Bei meinem disco sport wurde Castrol ATF Z verwendet nur ölwecheln öl ablassen neu befüllen 4 liter haben da reingepasst. Bin mir aber nicht sicher ob Castrol ATF Z wirklich für die ZF 9HP geeignet ist laut werkstatt ja

Hi Peter, what was the ticking noise? Was it ever diagnosed?

did you have to clamp off anything to stop fuel pissing everywhere?

Hi Peter do you know if this car play works with back hedrest screens and can u play netflix on this device

Nice video. Thanks. I am getting ready to do this on my 2015 Dynamic Evoque. It requires 0.9L of Castrol BOT270. What is odd is that in one section of the LR Service manual it says to remove and discard the drain and fill plugs (with no mention of the washers) and in another section of the manual it says to replace the washers with no mention of new bolts.

Very nice video. Did you measure how much you drained out? Everyone I have heard from that has done this claims they only get 1.8-2L out. I was hoping for 3 or 4L like you got. I have looked at the LR Service manual on Topix and it has some detailed procedure regarding checking the level. First you fill until it comes out the fill hole (like you did). But then you start the engine, press the brake, put it in reverse and wait 10s, then drive, then manual 1st, then manual 2nd and then park (waiting 10s with each change), then raise the RPM to 2000 RPM for 30 seconds. Return to idle and ensure that the transmission is between 95F and 113F. While the engine is idling, remove the fill plug and if fluid runs out, you are fine. If none comes out, then add more fluid until it runs out. I'm not sure how important this procedure is to checking the level.

Hi Peter, I have the same noise on the same side (2012 RRS SDV6) and, from what I have learned, this noise usually comes from the left side of the vehicle, is clearly audible from the wheel arch, and very little from above. Mine is coming only when the engine is in temperature but, that's weird, only after a drive. If I let the car warm up without driving, the noise doesn't appear. That raises a question: If it was one of the lifters the noise would occur no matter what, wouldn't it? Another one: the frequency of the noise is very far from one that a 24-valve lifter would sound, too low indeed, right? Since the noise tends to disappear as the revs go up, it's hard to state that the noise is coming from them, even assuming that the oil pressure rises with revs and cancels the gap. It's more like the sound of a chain, maybe the timing one where the variable phase operates with tensioners. And this will explain why the noise doesn't appear if don't drive the car but leave it warming up static. I will do some research and testing before tearing down that crap plastic covers to reach the cams. A nightmare. Thanks for your videos which I appreciate very much. Keep going. Cheers mate. Marco

My 2014 LR4 air suspension is just getting back to normal height after few minutes. For example, if I put it in the lower height, it will go to normal height after 0-10 minutes. The same thing when I put it in the higher height, it will go back to normal height after 0-10 minutes. What you guys think?

What size star screw you used to loosen rotor

Hi, I have the HSE with the GPS antenna on the roof by the tailgate, will this rack fit and miss the antenna? Thanks.

Is the filter located in the same place for north American models?

Great content Peter. I am trying to do the retrofit but cannot get the green auto symbol to show on the dash, even after updating the CCF using the GAP tool. Did you have auto or adaptive headlamps before the retrofit? Also, I saw that the CCF shall also be updated to rest of world? What do you think about that? Also if you take requests, fitting the memory function would be great 😀

Hello friend the number parts of control???? Please

hey Peter what happend to videos we missing you

J’étais à la castrol 5w30 edge j’avais pas de particule dans le filtre a 160000kms ensuite passé castrol magnatec 5w30 quelque particules dans le filtre a 180000kms puis là castrol magnatec dpf 45€ 5 litres le moteur sonne mieux et j’ai toujours quelques particule dans le filtre à huile a chaque vidange actuellement 211000 kms toujours des particules ds filtres est-ce du a l’huile magnatec je sais pas mais je fais vidange tout les 10000kms maintenant ! on verra bien jusqu’où il ira 3l v6 biturbo 245ch 2011

is this the same process for the 2012 LR4 5.0L V8?????????????????

Could you use the refill pump to pressurize the transmission and push out oil?

Land Rover told me my 2016 HSE dynamic has a sealed transmission, what do I need?

Huey, how is your penal holding up, some people reported theirs were separating.

Hello. A motor vezérlés láncot mikor ajánlott cserélni? When should the engine control chain be replaced?

Hi Peter, thanks for great video. I just followed your instruction and installed the module well. I'm using Android Auto and now people telling me my voice is really small everytime I make the phone call which never happened before installing this module. Do you have any idea? and is there a way to stick with my bluetooth instead of my audio set to Aux?

What is the special tool? 9:26

Hi, where did you order the fridge from?

Please tell me about those spot lights you have on your LR4 ? They look great .

I have to change my bulbs too but I have a bull bar installed. So to remove my grille is really tight.but I will persevere.

What were your transmission issues?

What tire pressure monitors did you buy for 70 euros?

Can you add a link to the part you ordered, please?

I dont understand to sell the better-looking lr4 to get another one, i own 07 lr3 and just bought a 04 D2 , the D2 has soild front and rear axles, which is excellent for lifting, excellent for offroad, i like the black lr4 better it gets very expensive to build a overland when you had everything on the black lr4 , im planning to buy a lr322 in future to build into a overland build you don't see many builds for ranger rovers even the 405 are becoming cheap to buy but the 405 is more rounded i like the square box look knobs & switches, having a computer monitor screen that controls everything not good if monitor goes bad 😊

I like the snorkel style better than this one

Appreciate your channel Peter, I own a DISCOVERY 4 2016 HSE LUX.... your videos are helpful, informative and easy to follow. 👍💯

Peter how can I understand if my Disco 2015 has Bosh or Harman Kardon system mine is Meridien. Thanks Mike

I mounted the foam gasket on top of (outside of) the metal mounting plate. That puts foam between the snorkel and the body instead of the metal bracket against the body. it protects the wing and has a better seal.

I'm having the same issue + I can't send the ECU Info, it says I can't generate email because I need to have an email account. My account has an email added to it, it's wierd. I wrote to GAP Team, waiting for their reply.

Much better. Don't like the wood in my Discovery

I have a D4 with 129k miles and changed to 5W40 and it transformed my engine - so much soother. i will try the diesel additive next. Great tip.

200 newton's that is for the caliper bracket

I have a 2014 LR4 and I'm learning so much, and saving a lot of money from watching Peter's videos. Two thumbs up!

Hi, can you do a video describing the process of replacing the original 19" wheels to the 18" ones?

Looking good!! Great mod!

To avoid air bags blowing, do what you did and then get ready to remove, after 20 minutes of no power from a disconnected battery. Good job, and most needed. Thanks for sharing. Kind regards.

Not sure what is different here than with my 2014 LR4. I've done all these steps, but still cannot successfully make a new key. I'm waiting for an actual OEM fob to come in the mail to see if that makes a difference, but so far I can't get this function to work, and it's the main reason I bought the tool in the first place to keep the dealership out of my pockets. UPDATE: As it turns out it was the aftermarket fobs that were worthless. I bought a used Land Rover fob with the logo on the back, and the IID Tool turned it into a working spare in 5 minutes. The fob makes ALL the difference.

So after having mine apart last night with the exact same noise I found the timing chain tapping the cam cover , new chain and tensioner it's perfect now

Very good video, thumbs up!

This looks like one of the better carplay add on units I've seen. I've been looking for something like this for my LR4.

Hi, where is the video on the door fix and renew?

Thank you for this!!!

Thanks for the very informative video, just about to replace mine👍🏻