3D Printing 101: Cura Settings Explained
ฝัง
- เผยแพร่เมื่อ 14 เม.ย. 2022
- Hey Guys I'm back with the start of a new series based around 3D Printing.
I've been doing this full time for around 10 years and I've teamed up with ZEN Filament to share some professional tips and tricks for successful prints.
If you have any requests for other 3D Printing Advice please let me know in the comment section below.
Check out the new Ultra PLA Filament by ZEN
www.zenfilament.com !
If you have any questions about anything in the video just let me know in the comment section below or on any of my socials @Brenmarten
Instagram: @BrenMarten
Twitter: / brenmaartens
Facebook: I don't have a public Facebook Profile yet.
Enjoy!
Links to things in this video:
The Cube Printed:
www.thingiverse.com/thing:127...
(Scale it by 30%)
Cura Download Link:
ultimaker.com/software/ultima... - แนวปฏิบัติและการใช้ชีวิต
![เก่งแต่ลับหลัง (FINSTA) - ส้ม มารี (Zom Marie) Ft. Punch 4EVE [Official MV]](http://i.ytimg.com/vi/OOolBU2aC70/mqdefault.jpg)
Skirt makes sure your nozzel is clean. The pre extruded filament wipes off during this stage
Amazing, so well explained
Great video!! This is helping me understand how to adjust my settings depending on the filament I use!!! Extra note (you probably already know this by now) if your using OBS to record this, if you want it to capture the popups you have to change to a screen capture (select the monitor) OBS considers popups in programs like this a separate instance than the actual program. (Just in case you didn't already know by now) 😅
Awesome my man, just what I needed.
Thanks for your all good work... looking forward for more, easy and understandable explains and 101's. keep it up.
Thank you James. This means a lot! I will find some more 101s to make some more content on soon!
i dont need further adhesion most of the time, and i user skirt just so the tip primes the filament before the print and most importantly to see if my tip is to high or to low against the bed. If is to low the 2 -3 skirt layer get squished to much onto the bed, if is to high the layers (3 skirt wall lines) dont toutch each other and there is space between them and get separated. Using skirt i can ajust the bed if needed on the go. If All is good the 3 kirt layer lines shoud toutch eachother forming one wide line. For bigget prints that dont have a wide bottom i use brimm
I would love it if this had bookmarks so I could go to a specific explanation without scrolling the entire video. But thanks for the vid. I bookmarked it.
Please please make a video going into the expert details of the printer settings 🙏
Hi Dane! Awesome that you asked. Busy filming a section about that at the moment! Thanks for the feedback!
how can you make the bed larger on the Cura when I was doing 3.50 it was working great now all of a sudden it’s only allowing me to put in 2.50
Hi! I have the problem that the yellow lines are suposed to be hollow and I can't edit them out. For example, I can't select the inside of a car wheel to be hollow. It's filled with the yellow lines and I can't find anywhere how to remove it. Please help, thanks!
Hi Carlitos, have you tried reducing your infill to 0%?