Diy brushless motor
ฝัง
- เผยแพร่เมื่อ 3 ก.ย. 2020
- Converting AC Induction 220v 250w broken fan motor to 12vDC brushless motor.
This is my diy Bldc motor tested with 12v and 18v. The brushless controller I used in this project was 24v 250w.
Any suggestions must be appreciated.Thanks
Here My diy ebike using homemade bldc motor😁
• Diy ebike using homema...
Diy Hoverbike friction drive
👉👉 • diy hoverbike friction... - บันเทิง
Sir pl provide winding diagram
And open one side cover and direct fan to the rotating windings in order to cool it down even better.
Thanks for your suggestions 👍
This motar is runing without hall sensor..?
Very nice..great work..👍👍👍😁😁
Thanks bro. You inspired me alot.
i was thinking the same thing with a dead 220v motor
What Name esc controller sir?
how many turns and whats the diameter of the winding wire? also did you use star winding?
Pls send me widing data and pol detaile od magnets
DIY brushlees controller please 🙏
Just a normal pwm driver 24v 250w link.coupang.com/re/SHARESDPNUL?pageKey=281219309&itemId=892784402&vendorItemId=5245539733
Bro winding video I want to know about it please guide me
Just follow this tutorial easy to rewinding
th-cam.com/video/-e7V4ReQouQ/w-d-xo.html
I make likr this too why not test the torque. That with thr towel 🤣. I mean you can try stop it right to test its full potrntial??
Project suspended 😁 because hoverboard motors are more cheaper than the motor that I built from scratch 🙂
@@RamannaSacca i see. How much turn and awg is use, i had try
22awg (single wire) 18turn
22 awg (3 wire paraller) 5 turn
(4 wire) 3 turn
5 turn had tone of torque
3 turn had torque but consume way too much amps like 10-15 amps noload
3phase 12turns per coil
Total 8 coil in series
(0.8mm single wire-20awg)
Feed the voltage 24v to the motor it consumes a round 6 to 7amp with no load.
The motor doesn't like higher voltage at all. I have tested with 36v with no load
is ok but on load got smoked😂 need to rewinding some day. How about yours still in use it?
Winding data plese