I unfortunately haven’t done a 4x4 rotor for a sport trac but one difference I do see is that on the RWD rotors it has studs for lug nuts but the 4x4 doesn’t so I would think maybe no rear bearing since it’s attacked to the hub/wheel bearing on the front axle
I unfortunately haven’t done a 4x4 rotor for a sport trac but one difference I do see is that on the RWD rotors it has studs for lug nuts but the 4x4 doesn’t so I would think maybe no rear bearing since it’s attacked to the hub/wheel bearing on the front axle
So this is a 2WD sport trac so the front is a spindle nut, no axle in the front. I couldn’t find the number so I tightened it until the rotors was flat flush and the bearings inside were fully seated. Then once tightened, I tightened it enough to align the holes for the cotter pin
"Don't want to over grease it" wth????? Never heard that before..... you pack it until the grease comes out the other end. You can't "over grease it" dummy
Well executed video man. Thank you!
Thank you for watching and the comment!
So looking like models with Rwd, the rotors and bearings have to come off. But 4x4 models only rotors come off and not bearings?? Thanks dan
I unfortunately haven’t done a 4x4 rotor for a sport trac but one difference I do see is that on the RWD rotors it has studs for lug nuts but the 4x4 doesn’t so I would think maybe no rear bearing since it’s attacked to the hub/wheel bearing on the front axle
I unfortunately haven’t done a 4x4 rotor for a sport trac but one difference I do see is that on the RWD rotors it has studs for lug nuts but the 4x4 doesn’t so I would think maybe no rear bearing since it’s attacked to the hub/wheel bearing on the front axle
Attached*
I learned so much thank you.
Thank you
Thank you for watching and the comment!
Need that starter guide 👀
what is the torque spec on the axle nut
So this is a 2WD sport trac so the front is a spindle nut, no axle in the front. I couldn’t find the number so I tightened it until the rotors was flat flush and the bearings inside were fully seated. Then once tightened, I tightened it enough to align the holes for the cotter pin
Does this work on a 2016 Honda Accord Sport?
Is it 4 wheel drive?
Unfortunately not, I’ve been trying to find myself a 4WD because I’ve been wanting to start a build series on it for over landing
Nice man
Need a tutorial on changing blinker fluid next!
👏🏽👏🏽👏🏽👏🏽
"Don't want to over grease it" wth????? Never heard that before..... you pack it until the grease comes out the other end. You can't "over grease it" dummy
Thanks for watching and the comment