Hot Rod Reverend
Hot Rod Reverend
  • 109
  • 323 717
Easy DIY How to Clear the Fog on Your Headlights
We break away from the normal action for 50's Ford content to present a very simple and effective way to clear the fog on those plastic headlights!
Listed below are the links for the products.
Rupes DA Coarse Polish
a.co/d/bAZ9J0S
3" Wool Buffing Pads
a.co/d/e2OFzpq
Sandpaper
600 a.co/d/1ChFapL
1200 a.co/d/gJkz2ci
2500 a.co/d/55iUAx8
มุมมอง: 1 122

วีดีโอ

How to Install Bosch-style Relays for your Headlights!
มุมมอง 1352 หลายเดือนก่อน
Aftermarket headlights have been installed in the 1955 Ford Fairlane for several years now with no issues. The car has a 12 volt system with a Rebelwire harness. After driving the car at night quite a bit over the summer months, the headlights began flickering after several minutes of operation. At first, I thought it was a ground issue. However, it turned out to be too much amperage flowing th...
ACCEL 2020 Points Eliminator Ignition Kit Installation & Review
มุมมอง 2K2 หลายเดือนก่อน
The ACCEL 2020 Points Eliminator Kit is installed in this video of its operation in a 1955 Ford 292 Y Block V8 running on 12 volts. Also, a review of the components shipped in the package is given along with closeups of the internals when installed in the distributor.
How to Repair the Rear Main Seal Retainer on a 292 Ford Y Block
มุมมอง 4392 หลายเดือนก่อน
I finally get around to repairing a nuisance issue with the rear main seal retainer that was delivered with remanufactured 292 Ford back in 2007. These retainers are made of aluminum, and one of the bosses had stripped threads that have continued to get worse over time. Instead of removing the entire retainer and dealing with a new seal, new side seals, etc, I found another solution and it work...
Harbor Freight Zurich Digital Timing Light 57678 Review and Demo
มุมมอง 2.6K3 หลายเดือนก่อน
I recently purchased a digital timing light to help me tune my ignition and double check the centrifugal advance in my distributor. While I do own a 1955 Ford, the distributor is from a 60's F100 - therefore, it does have centrifugal mechanical advance. There is also an ACCEL 2020 points eliminator kit installed in place of the points and condenser. The link to the Harbor Freight unit is below:...
How to Restore Headers with Rupes DA Coarse Polish - By Hand!
มุมมอง 1994 หลายเดือนก่อน
In the last video on the Summit carburetor tuning, we had a serious mishap! The flexible foam fender cover MELTED onto the driver's side header of the 292 Y Block. There was quite a bit of residue. Enter Rupes DA Coarse Polish, a microfibre towel, a 3M scratch pad, and some good old fashioned elbow grease. I could not believe the results! www.amazon.com/RUPES-Coarse-High-Performance-Cut/dp/B08H...
How to Troubleshoot a Summit Carburetor with Lean Idle Problem
มุมมอง 2.8K4 หลายเดือนก่อน
This video troubleshoots a 500 cfm, four barrel, vacuum secondary carburetor IDLE problem. Whenever this Summit carb gets up to operating temperature with the engine, it exhibits a lean condition. A Summit idle feed restriction kit was purchased, and the carburetor was pulled from the engine, analyzed, received a new set of primary idle restrictors, brought to a baseline, re-installed, and give...
How to Replace the 1955 Ford Fairlane Speedometer Cable Assembly
มุมมอง 6616 หลายเดือนก่อน
The speedometer on the dash is making noise. Is it the cable? Let's find out. In this video, the entire speedometer assembly is removed from the dash, the cable/housing is removed and replaced, and the 1955 Ford is road tested to confirm success. Helpful review on reproduction parts and lube is also included. Visit HotRodReverend.com for articles, photos, videos, and a boatload of DIY on 50's F...
Monroe Sensa Trac 58539 Rear Shocks 1955 Ford Install & Road Test
มุมมอง 4556 หลายเดือนก่อน
Unboxing, review, install, and road test of a set of Monroe 58539 Sensa Trac Load Adjusting rear Shocks for the 1955 Ford Fairlane Club Sedan. Visit HotRodReverend.com for helpful articles, technical advice, and a full build blog on the Y Block-powered 55 Ford.
1955 Ford Fairlane Driver's Door Window Glass Installation
มุมมอง 5558 หลายเดือนก่อน
HotRodReverend.com Part 2 of the work on the 1955 Ford Fairlane Club Sedan - The glass from AutoCity Classic arrives and is set into the channel. The glass is installed in the door, the division bar reset and adjusted, and away we go!
1955 Ford Fairlane Driver's Door Window Glass Removal
มุมมอง 1.1K8 หลายเดือนก่อน
Part 1 of 2 - The removal and installation of a driver's side door window glass is archived in these videos. You can visit HotRodReverend.com to see more of the work on this 1955 Ford Club Sedan that I have owned for almost 35 years. The video covers the necessary tools and their uses, information from the shop manual, closeups of various hardware, and all of the work from start to finish. This...
TP Tools Blast Cabinet Review and Seal Replacement SkatBlast
มุมมอง 4779 หลายเดือนก่อน
I have owned the 780 SkatBlast cabinet for over 15 years. This video includes a review of the unit and a replacement of the plexiglass lens and seal. For paint and rust removal on just about anything made of metal, you cannot beat the versatility and quality. The blast cabinet is supplied 13cfm of air from a 60 gallon 5 HP US General air compressor at about 90 psi.
Leaf Springs Removal, Installation, and Test Ride - 1955 Ford
มุมมอง 1.9K10 หลายเดือนก่อน
Leaf Springs Removal, Installation, and Test Ride - 1955 Ford
Summit Carburetor 500 cfm Electric Choke Initial Start 292 Ford Y Block 1955 Ford Fairlane
มุมมอง 3.5Kปีที่แล้ว
Summit Carburetor 500 cfm Electric Choke Initial Start 292 Ford Y Block 1955 Ford Fairlane
Aftercooler for 60 Gallon Harbor Freight Air Compressor
มุมมอง 53Kปีที่แล้ว
Aftercooler for 60 Gallon Harbor Freight Air Compressor
Summit Carburetor Swap for the Y Block 292 V8 SUM-M08500VS 1955 Ford
มุมมอง 12Kปีที่แล้ว
Summit Carburetor Swap for the Y Block 292 V8 SUM-M08500VS 1955 Ford
12 volt to 6 volt Fuel Gauge Conversion for the 1955 Ford Fairlane
มุมมอง 6K2 ปีที่แล้ว
12 volt to 6 volt Fuel Gauge Conversion for the 1955 Ford Fairlane
2022 Y Block Shootout Hot Rod Reverend vs Harry Hutten
มุมมอง 2.6K2 ปีที่แล้ว
2022 Y Block Shootout Hot Rod Reverend vs Harry Hutten
Hot Rod Reverend and the 1955 Ford Fairlane at the 2022 Y Block Shootout!
มุมมอง 15K2 ปีที่แล้ว
Hot Rod Reverend and the 1955 Ford Fairlane at the 2022 Y Block Shootout!
2022 Y Block Shootout Bye Round Hot Rod Reverend's 1955 Ford Fairlane
มุมมอง 1.1K2 ปีที่แล้ว
2022 Y Block Shootout Bye Round Hot Rod Reverend's 1955 Ford Fairlane
KR Wilson Lifter Tool Set for the Y Block Ford Engine
มุมมอง 5K2 ปีที่แล้ว
KR Wilson Lifter Tool Set for the Y Block Ford Engine
1955 Ford Fairlane Exhaust Down Pipes 292 Ford Y Block with RexHP Headers
มุมมอง 1.4K2 ปีที่แล้ว
1955 Ford Fairlane Exhaust Down Pipes 292 Ford Y Block with RexHP Headers
Y Block Ford Camshaft Install (in car!) part 4 - final episode
มุมมอง 2.6K2 ปีที่แล้ว
Y Block Ford Camshaft Install (in car!) part 4 - final episode
Y Block Ford Camshaft Install (in car!) part 3
มุมมอง 3.7K2 ปีที่แล้ว
Y Block Ford Camshaft Install (in car!) part 3
Y Block Ford Camshaft Installation (in car) Part 2
มุมมอง 6K2 ปีที่แล้ว
Y Block Ford Camshaft Installation (in car) Part 2
Y Block Ford Camshaft Installation (in car!) Part 1
มุมมอง 11K2 ปีที่แล้ว
Y Block Ford Camshaft Installation (in car!) Part 1
RexHP Y Block Header Install and Review - 1955 Ford Fairlane
มุมมอง 3.3K2 ปีที่แล้ว
RexHP Y Block Header Install and Review - 1955 Ford Fairlane
Y Block 312 Ford Hi-Lift Barker Rocker Arm Assembly Rebuild
มุมมอง 4.2K2 ปีที่แล้ว
Y Block 312 Ford Hi-Lift Barker Rocker Arm Assembly Rebuild
Y Block Header Project Part 2
มุมมอง 1.7K2 ปีที่แล้ว
Y Block Header Project Part 2
Y Block Ford Custom Header Project (Part 1)
มุมมอง 2.9K2 ปีที่แล้ว
Y Block Ford Custom Header Project (Part 1)