@@dougwitherby3291 if you have a press press the axle down unto the bearing and use a Yukon or a spicer cause the jarring of pounding bearing in tends to separate the bearing if u look at bearing there’s a little ring on the end that comes off there’s another video of pressing it on
Friend, please tell me, I have a 2014 Jeep Sahara! rear axle dana44, go to the outside half-axle! bearings break after 60-100 kilometers! tell me what could be the problem? Thank you
@@gordonoliverjr2363 yeah I think I ran Accross something like that before in Jeep turn the axle back and forth and then hit the center of axle firmly to force axle in the splines it’s like the tube isn’t lined up with the center section
great job
Хороша робота!)
Well done 👏 where did you get the pipe to drive new bearing on?
@@dougwitherby3291 actually don’t remember I think found at day job
@@dougwitherby3291 if you have a press press the axle down unto the bearing and use a Yukon or a spicer cause the jarring of pounding bearing in tends to separate the bearing if u look at bearing there’s a little ring on the end that comes off there’s another video of pressing it on
@@richierock1300 thanks!
Friend, please tell me, I have a 2014 Jeep Sahara! rear axle dana44, go to the outside half-axle! bearings break after 60-100 kilometers! tell me what could be the problem? Thank you
@@kromik6965 what breaks ? The axle or bearing goes bad
@@richierock1300 The bearings are breaking, it feels like the axle is sticking out by 1-2 millimeters
@@kromik6965 is it leaking oil or making noise driving if so replace it
@@richierock1300 changed twice already, after 60 kilometers it breaks, they can't find what causes it
I can’t figure out what’s stopping the splines from lining up.
@@gordonoliverjr2363 axle into the side gears
@@gordonoliverjr2363 yeah I think I ran Accross something like that before in Jeep turn the axle back and forth and then hit the center of axle firmly to force axle in the splines it’s like the tube isn’t lined up with the center section