Building a Club Start to Finish

Showing the start to finish process of building a single club, including mixing the epoxy, prepping the shaft, installing the ferrule and final assembly.
Please subscribe, and use the comment section to ask any questions. Also feel free to reach out on Twitter & Instagram:
rdsbarath?lang=en
rdsbarath?...

[@justinkilgren9138]

Awesome tutorial! Honestly one of the best I’ve seen as far as straight and to the point basics. Too many others that either forget to mention steps or get off track and ramble on.

[@cahal21]

Nice video, definitely nice to see it all start to finish and have to say I was surprised how little epoxy is needed, felt like I've used more in the past so good learning for me there! Thanks.

[@davidosullivan6351]

Cool Vid, Try pick up a microphone, really helps and makes sound more crisp. Keep these type of vids coming 👍

[@garyyip8854]

Awesome video again - it's nice to know that I'm following the exact same steps! No questions this time relating to the build but how about a WITB? I'm guessing you're like the rest of us - big club junkie - so I'd love to know WITB and what clubs are trying to 'audition' to get into the bag ;)

[@sorenmikkelsen7880]

Was is salt you used as filler?

[@rrrrandall]

What scale do you use? I bought one that does .1 gram resolution, but I can tell it's not accurate.

[@CorwynRaesz]

Would you say that those steps are more or less the same for putting a new shaft in a putter head? Minus the ferrule, of course.

[@rich1eleven]

Do you do swingweight calculations on the individual components before assembly or do you adjust swingweight post assembly?

[@ryanbarath1916]

I always calculate pre-build to within a tolerance and then do final calculations once glued and before grips go on

[@Cupillac]

Do you line up shaft with logos/lettering on the back side?

[@ryanbarath1916]

yes, most installations are logo down

[@erikcrossley5048]

What is your take on "puring shafts"? In this video you seemed to just put it in any orientation.