I have the g372xp holzfforma and so far the only issue was the oiler doesn’t oil the bar or chain but somehow the bar oil container gets low in going to try and get a Oregon bar n chain and replace the oil pump and see if that changes anything
Usually from FARMERTECS website. Usa stock section. But a lot are sold out right now, so you can just find another vendor that sells FARMERTECS like bluesaws.com. I bought a few from them.
Your 444 is a great running saw. I have a G288. It came pretty good from factory. Just needed a tune. Cheers
I have an old Husqvarna 61 that I put a 268xp cylinder with a popup piston. Makes 215 psi and it rips for a 61 . Cheers
G660 king my opion compare to 444 and 466 .. after break-in put a brand new Bosch plug in blue or orange they like Bosch plugs.
Good review. I have the g372xp, had to replace the carb.
I have the g372xp holzfforma and so far the only issue was the oiler doesn’t oil the bar or chain but somehow the bar oil container gets low in going to try and get a Oregon bar n chain and replace the oil pump and see if that changes anything
Where do you buys your clone saw from?
Usually from FARMERTECS website. Usa stock section. But a lot are sold out right now, so you can just find another vendor that sells FARMERTECS like bluesaws.com. I bought a few from them.
044 and 046 the same saw just different jug and piston?
@@AA-tb4ff case is different. Crank is wider on 460
@@rkfirewood7576oh ok thanks for the reply