RC Car Not Driving Properly and Electronic Speed Controller Calibration

Troubleshooting the drive and speed controller on an RC car. The initial problem was an unpredictable response to the throttle which can be due to mis-calibration of the ESC, in this case it was two issues: One, the ESC required calibration and two, the transmitter reverse control was not functioning, which became apparent while calibrating the ESC. Swapping out the transmitter / receiver pair allowed the ESC to be calibrated correctly.

[@sethturner6399]

Thanks really needed this

[@josephmorelli3191]

Very nice video! Seriously, I have a lot of trouble grasping written directions. Your video was very clear to me. Thank you!

[@gregmaggert8561]

Awesome video thank you

[@overfly_pt]

Great video thanks

[@Ghostcars20]

Well I didn't have a break and only forwards throttle so thank you

[@idiots830]

After connecting 2 motors to 2 ESCs, without knowing to remove the red wire on one side of the BEC, I connected them together to the servo controller of 1 and tested the operation for about 30 minutes?? So, only one motor worked, the other motors operated randomly, and in the end, the ESC on the motor side, which was working well, was damaged and did not work at all. When I went to TH-cam, I saw a video about removing one BEC. I removed the ESCs one by one, reset them, and tested them. Of the two ESCs, only the motor side, which had been malfunctioning uncontrollably, works. When I turn on the power, the motor makes the same beeping sound that it made before starting, but even when I move the throttle, it works. The motor doesn't move at all. Is there no way to save it??

[@m_0nrz]

Help i have a problem with my rc car it always stop 2 sec after moving