Nooooo! I was wanting to see you do the other side and thought you were going to show us… Did the ball joint tool work on that other end you didn’t show? Also was it as smooth as the one you just did?
@@genericusername1365 I think in this case I would have needed the longer ball joint c clamp to fit all the giant fittings for that giant bushing. I am sure you could make it work if you had less lengthy tubes of the correct diameter for that bushing
Sounds like a Rotary engine
Can this be used for that bushing as well?
It could if you had the right sleeves and plates and a longer ball joint press. I ended up doing it on a shop press.
Nooooo! I was wanting to see you do the other side and thought you were going to show us… Did the ball joint tool work on that other end you didn’t show? Also was it as smooth as the one you just did?
I ended up using my shop press with ball joint tool and wheel bearing tool fittings! I made a video about it right at the same time as this one
@@hardcore4476 th-cam.com/video/yc_SCDfM0OY/w-d-xo.html
@@dragon_offroad So do you mean that the C-clamp ball joint tool will not work to press in the larger donut bushing for the control arm?
@@genericusername1365 I think in this case I would have needed the longer ball joint c clamp to fit all the giant fittings for that giant bushing. I am sure you could make it work if you had less lengthy tubes of the correct diameter for that bushing
Which year Honda accord is this from?
This was a 2008 honda odyssey exl
Genius!
Nice job. Can you send me the link to that tool?
This is the one I used:
DAYUAN Universal Ball Joint... www.amazon.com/dp/B07CBSB1C1?ref=ppx_pop_mob_ap_share
@@dragon_offroadthanks dude!
do you have a video that how to remove that ball joint on control arm?
The aluminum control arms do not have replaceable ball joints
Thanks
Is this for a Subaru STI?
@@juliomiranda6801 it could apply to any pressed bushing but this is a honda odyssey
@@dragon_offroad thanx looks very similar to
On and off the button? Lay off the drugs