5th Gen Camaro HVAC Blend Door Replacement

My 2012 Camaro is stuck on heat on the driver side. I suspect it’s the blend door under the steering wheel. In this video I try a hack in cutting into the side of the HVAC box that houses the blend door to replace it.
737 Mechanic Link: • 5th Gen Camaro Blend A...
#camaro

[@stevepolito8910]

Just did today. Your video along with 737’s were a huge help!

[@kevinl3235]

Nice job!

[@737mechanic]

Great video, subscribed. ✌

[@KCSGARAGEMEDIA]

thx!

[@Fastaction9]

I’m going to have to do mine this weekend

[@SickoTexas]

Does it matter which way the blend door is facing when it’s replaced ?, like on full ac mode or heater?

[@GregGersabeck]

QUESTION: am in the process of doing this repair and have hit a snag. The shaft on the actuator motor won’t align with any position that I can adjust the newly installed blend door. It's just slightly off but enough where I can’t even re-bolt the piece on. I’m thinking I can reset with a 9V battery, but can’t find the pin assignment to test. (GM Part # 92215208/ACDelco Part # 15-74128) Any advice would be appreciated. Thank you for your videos!

[@jeremiahwarren255]

Can anyone do this on my 2015 Chevy Camaro LT? Will pay for labor + flight/gas + hotel (if needed) to get to Nashville, Tennessee or I can drive to you if you’re somewhat close to nashville. Chevrolet quoted me at nearly $4,500…

[@krazor8]

About to it on my 2013 ss vert

[@coreybird8609]

PLEASE HELP!!!! What are you using to see the problem codes and force the car calibrate everything ? What every you used to clear the body control module mfault codes! Please help how do I buy one!

[@guallpafx9487]

Do you have to use the scan tool?

[@danelmassey9535]

not if you disconnect the battery.

[@dadracco8825]

What was the a.c doing blowing hot air on the driver side or both side

[@VCR0010]

Driver side get hot and passenger gets cold.

[@lnrajcummings7924]

How did you get that damn plastic off

[@jando925]

what scan tool is that?

[@KCSGARAGEMEDIA]

Here is the link to it
LAUNCH X431 PROS Mini... www.amazon.com/dp/B071DQPN4N?ref=ppx_pop_mob_ap_share

[@IceManInDaCut]

I don’t understand why they make to so fkn difficult to fix stuff like this that’s bound to break… it’s like they want it to be a pain

[@mateorocks86]

They do it so you can bring it in

[@BennettOverFame]

I watched this to figure out how to take out the control module, HVAC tube, and actuator motor before getting to the cutting. Smh.

[@joemarks3719]

Glad to know you were able to do it at 6'2". I am the same height as you.
Curious if removing the rear seat bottom would help with room?
It's only held in by two clips and comes out very easily.