How to replace the headlight on a 2015 Subaru Forester

[@maureenbailey4094]

This was the easiest to follow tutorial I have seen. You saved me time and money - thank you!

[@syissauer]

Thanks, now I’m out $11 instead of an $80 shop visit. Much appreciated.

[@georgettelamb4613]

Thank you. Will be doing this today. Appreciate people who take the time to share their knowledge.

[@sarahmzollinger6148]

Very clear, easy to follow and understand, without a bunch of unnecessary explaining. Great video. Thank you so much!

[@jamesoconnell5295]

Thanks for the video. Only took me about 4 minutes to change my headlight. Since the video, the price of the H11 went up $8

[@allisonlarson5576]

Very great instructions and demonstrations. Got mine changed! I did have to use a flathead screwdriver to get the plug off, but so much easier than expected!

[@andrewseymore4506]

Thank you so much, even easier than expected

[@WindowGeek1]

Very clear and straightforward video. Great job!

[@s3radane]

Thank you so much for this! Had both of my bulbs replaced within 5 minutes after watching. Excellent video!

[@pauldavis5489]

Thank you Sir! That took all of a minute.! Way better than replacing a headlight on my neighbors Mazda 3 with their weird rubber band set up!

[@Joe-ev5xz]

This is excellent and I’m changing mine today. Much appreciated!

[@narutoutzumaki1036]

I can't describe how helpful this was!

[@brianjs]

Thanks for posting this! Replacing the headlights on my Subaru today.

[@fiouable]

Wow now I also know how to open the hood. Thanks the video. The lighting and sound were perfect. I use a dab of tune-up grease on the red O ring. Helps a lot when you tighten back the bulb.

[@sherylm2106]

Thanks so much for this video! You did a great job and now I am replacing my light today. Thank you again 🙏🏼🙏🏼🙏🏼

[@Blimpie1000]

Thanks. Very clear and well done with good camera angles

[@iudenden]

Thanks for the video. I would say though that at the moment (1:04 min mark) where you have to detach the bulb from the plug, it does not give as easily as shown in video. There is a little clip that is on the backside that can be more easily loosened with a flat head. At least I was unable to just pull that plug away without moving that piece a bit.

[@mikebaker6943]

Well done. You saved me time. You are appreciated!

[@darkenrahl2327]

To disconnect the light, there is a small clip that runs down the middle of the connector. Press it

[@danielc8818]

Was going to say the same thing. Need to do this first to disconnect that electrical connector

[@jenniferaquila552]

Thank you for your comment. I was struggling

[@toddsmith4280]

I had to use a flat head screw driver to press the bottom of the clip. The it rotated just abut an 1/8 inch out. Then it pulls off easy.

[@johnmathews1656]

Thank you! Very clear, especially getting the shot inside the hood!

[@kasyamestnik5799]

Thanks so much for this! The tip about wearing gloves was good to know

[@johndantoni6852]

I had to slip a small flathead screwdriver down the connection between the pigtail and the light unit to unclip the pigtail. It was easy to remove after that. There was a connection piece (snap) of plastic holding it to together.

[@jenniferp1917]

Yeah, I can NOT get that dang pigtail off the light unit! I keep watching videos and they all just say "oh you push this button (that you can't even see because my hand is in the way) and it just pops off!"
Or like this video..."you just pull it down"
And it won't work for me and I already broke off one tab...

[@malhamishery9]

Thanks, you probably saved me over $50.

[@friendlyporkchop]

thanks for this! used it to replace a bulb in my car today

[@chrissavage6163]

Easy peazy! Thank you!

[@stevencortez888]

Great helpful video merry Christmas

[@simonhughes9560]

Thanks for posting buddy!

[@xnademolicious]

Perfect, thanks. I appreciate the video.

[@grownmanoutdoors4274]

Hope it helped speed up your repair! Thanks!

[@M41N3LY_G4M1NG]

Thank you for sharing.

[@kylegomez7287]

Thank you! Very Helpful

[@toddsmith4280]

Thank you. Latest price from O’Reilly was $18 plus tax.

[@rickclayton3046]

That was easy. Thank you!

[@bordercollie1255]

Excellent demonstration. Thank you! 🙏

[@ronibo9]

This was so useful, thank you

[@rodinnis421]

Thanks! This was helpful!

[@paulcarey1708]

Thanks Dude! There are some fancy LED bulb sets available to replace the H11 bulbs.... really don't think paying 10 times the price is remotely justified.

[@Tathlon1]

Thank you!
Great help!

[@garthfarkley]

Thank you.

[@charlesnoska2225]

Thanks for the video. Unfortunately the title is incorrect, missing the word bulb.

[@vegangurl4eva]

Thank you!!

[@NathanJNowak]

Thank you!

[@reedkellner6447]

Appreciate it

[@LPRO1685]

I uninstalled the low beam light and I was unable to install the H11(wrong spot). I almost left for the store but then I realized my mistake.
High beams/low beams
Know the difference

[@logannMan]

Literally the only confusing part about this is getting the fucking plastic piece off and what are your instructions? To “manipulate it” and “loosen it”. What in the fucking fuck does that mean dude? Am I supposed to just rip this off. Which DIRECTION do I push? WHERE do I hold it? Fucking fuck fuck fuck fuck

[@amymglass3737]

Geeze a lil high strung are ya?