How To: Replace your center serving | Do it TODAY!

Don’t live with center serving separation it’s super easy to replace!
Serving Jig: amzn.to/3kuxxG3
Serving: amzn.to/3ksXE01
Dudley’s video: • HOW TO REPLACE A CENTE...

[@aaronhall765]

Great job and video.
An important note. They're different diameter servings. It's critical to get smaller for higher string count, and if you're going to run tag end full length. If you have thicker servings or thicker string you may not want to run tag end full length. To thick causes poor nock fitment.
Keep you the great content! 👍 Mahalo

[@PrivilegedBowhunter]

Great point!

[@jasonard7227]

been wondering none of your stuff is showing up on my feed glad I found it when I searched..

[@joshsorensen9216]

Love your content. Thanks for the new video.

[@PrivilegedBowhunter]

Thanks boss

[@wcwcgarner2717]

Nice job. The serving looks great.

[@PrivilegedBowhunter]

Thanks bud

[@jasonard7227]

I had the hardest time doing it like this my string would just twist up. the hard part for me was just getting it started. I wound up taking the string off the bow and used my draw board boat winch and my scale put a 100 pounds on it and did it that way. seemed to be easier that way for me the start was still a pain lol...gonna try your way with the start next time. thx for sharing man God Bless

[@Bluesplayer789]

I appreciate these home-shop vids, I remember the first time I worked up the courage to change top hats....I was packing death as I took the axles and cams out but I guess only one way to know if you can do it! Thanks for your videos.

[@PrivilegedBowhunter]

🙌🏾Nothing to it but to do it

[@Goody2525]

Nice video! I just got the jig and serving last week because my nocks fit too tight on my current serving. I’ve never done it before but you made it look easy.

[@PrivilegedBowhunter]

Check your nock fit early, if it’s too tight don’t run the tag end all the way down.

[@caninphx]

​@@PrivilegedBowhunter or you can actually look up the dia of the nocking point, measure your string dia,then figure out the dia of serving you need.

[@PrivilegedBowhunter]

Smart…thank you 🙏🏾

[@raymondjones6024]

Serving separation isn't my issues with tied top and bottom nocksets and using BCY #23 I get accuracy problems that nobody mentions with flat spots from Easton Xnocks in the serving over time that effects nock fit within the throat of the nock during the powerstroke on the shot that gave me a consistent left impacts with the factory .21 diameter serving on the factory Mathews Trophy strings

[@DaveyDave1923]

How often do you change your strings and cables? Good Job!!

[@PrivilegedBowhunter]

They’re actually due for replacement. When you see fray on the string or cables it’s time to replace.

[@v.l.bradley9962]

if my serving separates I end up getting nock pinch from my D loop