You are headed in the right direction. In the past I have welded, built and rebuilt a few Flat fender and CJ bodies and I like the way you formed your curved areas. My only suggestion is to make yourself a set of bending bars to form your curves if you have access to a hydraulic press that would be used to press in bearings, bushings and seals. This would make your life easier. Keep up the good work. And can't wait for your next episode.
You are headed in the right direction. In the past I have welded, built and rebuilt a few Flat fender and CJ bodies and I like the way you formed your curved areas. My only suggestion is to make yourself a set of bending bars to form your curves if you have access to a hydraulic press that would be used to press in bearings, bushings and seals. This would make your life easier. Keep up the good work. And can't wait for your next episode.
Thank you! I’ve had a few cjs as well, I definitely want to upgrade my sheet metal tooling soon!
This is looking great! I would dump that exhaust right into the drivers frame rail…. Fun project!
Thank you, I didn't think about doing that, but I could run the exhaust through the frame.
Nice truck ramps
The best
That’s gonna be a sweet build, it’s to bad you couldn’t have put in a V-Twin B/S horizontal shaft engine , with a transmission in it ❤
Yeah with the trans I have Im limited to a vertical shaft engine, or else I would have.
Willy Wonka
Thanks I think
Looks like a Pedro dunno y
I’ll have to look that up
@mikefestiva
Thanks for watching!