I have an Audi A4 and at first it was just cranking and wouldn’t turn over but if I gave it gas while cranking it was able to turnover but it was shaking and the engine light started blinking I drove it in circles around a parking lot to see if it would get better and it didn’t and when I parked and turned the car back on there was no crank and it didn’t turn over just the battery was working
It could be the crank sensor but also I’m thinking you had dirty injectors and or bad coils . I would check the coils , injectors and the crank sensor . Plan on doing a big job on it not just scratching the surface . What year is it and what engine ?
Check it with a OBDI, even a real cheap one. It will bring up the specific P# code for Crank sensor. My B6 one went bad suddenly & my cheap OBD1 told me that too. It worked ok under 50°C but went bad over that. Engine light stayed on once it was triggered, only drove it twice when it went bad anyway. Cheap easy fix.
So I got an 11 Quattro. Had the crank no start issue but would try to catch and would barely run for a couple seconds. Now when I try to start it, it doesn’t sound at all like it has any kind of combustion. Sounds like the motor is turning over without any load very quick rather than a slow kind of cranking noise. Any idea?
Question: my car 1999 1.9 tdi 110 started faster then most petrols, however I had this trailed to a new location and it’s never ran right since, air lock, bleeding the fuel lines to try and get this to start, nothing one thing I do notice the Rev counter doesn’t move when turning over and the diesel doesn’t shoot out the cracked open injectors ? Could this be a broth fuel pump? Thanks
Never worked or had a diesel car, if I tell you anything, it will be a lie hhh sorry . I’ve been wanting to have a diesel one just to know more about diesel motors but at the moment sorry I couldn’t help
my audi a5, went from 140km to 50km at highway and didn’t go higher. and after i stopped the car it wont start again. car want to start but nothing happpening. is it the same problem?
Same problem just happened to my q5 , your car jus like like mine was consuming oil more and more till it stopped running :solution : engine tear down , piston ring job must be done or engine replaced
Your vedio you mention this might be. I feel you need to mention the engine components by name so that we will know were you coming from otherwise thanks for the vedio
I think the last time I checked I found out that I don’t work for you , you need to teach yourself some manners , respect and appreciation, be thankful that someone made all that effort to make this vedio possible , people like you who made me stop posting more vedios . You don’t deserve my time and effort.
Did your car turn over and start up sometimes, or was it just dead. My sometimes takes a long time to start. Any ideas have to crank motor for 30 to 40 seconds to start . It is to fire right up
It's a common problem that the seal breaks or gets missalligned on the ECM box and water gets into the box which will kill the two relays under the computer. I had this problem and had to swap relays multiple times because of water kept getting into the box, sealing the box properly is not the easiest so I suggest finding a new lid with seal. Eventually i had to swap out my ECM as it was water damaged.
I totally get it but this is OBDeleven ultimate , it’s called that way . It’s made in Lithuania , there is starter, basic, pro and ultimate. And it’s called OBDeleven. Type this word in your phone and you’ll see the app :) I’m saying this to you in good sense as well not to make fun of you. Thanks for watching , the vedios that are coming next will be really good ,
Hey, I would like to know what Pxxxx code you got with OBDII, got the problem 3 days ago with 1.8T 225HP my daily, and it was starting right for 5 minutes in the morning , turn off and it won’t start after all later!
I don’t really remember but the code sent me directly to the crank sensor , Try to put a new crank sensor to see if the problem is gonna go away . Also see if the rubber tube coming out of turbo if open or cut , if it’s open the car will crank but won’t start
So the hole you showed at 2:00 is that where the sensor goes? If so how did you plug it in?
Tbareklah 3lik a khoya
شكرا جزيلا
Did you calibrate using obd scanner cam/crank relearn?
I have an Audi A4 and at first it was just cranking and wouldn’t turn over but if I gave it gas while cranking it was able to turnover but it was shaking and the engine light started blinking I drove it in circles around a parking lot to see if it would get better and it didn’t and when I parked and turned the car back on there was no crank and it didn’t turn over just the battery was working
Do you think this is the crankshaft sensor ?
It could be the crank sensor but also I’m thinking you had dirty injectors and or bad coils . I would check the coils , injectors and the crank sensor . Plan on doing a big job on it not just scratching the surface . What year is it and what engine ?
Check it with a OBDI, even a real cheap one. It will bring up the specific P# code for Crank sensor. My B6 one went bad suddenly & my cheap OBD1 told me that too. It worked ok under 50°C but went bad over that. Engine light stayed on once it was triggered, only drove it twice when it went bad anyway. Cheap easy fix.
Same. Exact. For me. Is it fixed now? Please tell me what was wrong
What was ur issue?
So I got an 11 Quattro. Had the crank no start issue but would try to catch and would barely run for a couple seconds. Now when I try to start it, it doesn’t sound at all like it has any kind of combustion. Sounds like the motor is turning over without any load very quick rather than a slow kind of cranking noise. Any idea?
Broke timing belt or timing belt pulley replace it and check to make sure you don’t have any bent valves
Hi, can this sensor caused a sudden stall at a red light?
Yes , that’s what it does most of the time or after you park then want to drive again
Yes
Question: my car 1999 1.9 tdi 110 started faster then most petrols, however I had this trailed to a new location and it’s never ran right since, air lock, bleeding the fuel lines to try and get this to start, nothing one thing I do notice the Rev counter doesn’t move when turning over and the diesel doesn’t shoot out the cracked open injectors ? Could this be a broth fuel pump?
Thanks
Never worked or had a diesel car, if I tell you anything, it will be a lie hhh sorry . I’ve been wanting to have a diesel one just to know more about diesel motors but at the moment sorry I couldn’t help
U ever had a problem with the 395 relay under the ecu
I got a Chevy manifold pipe on mine as well
Do you have any idea why an Audi fans don’t start but after I take out a fuse they go 100%
I have a vedio for that , look at my first vedios
@@strictlyaudis7012 nice
👏👏👏👏👍💯💯💯
my audi a5, went from 140km to 50km at highway and didn’t go higher. and after i stopped the car it wont start again. car want to start but nothing happpening. is it the same problem?
Same problem just happened to my q5 , your car jus like like mine was consuming oil more and more till it stopped running :solution : engine tear down , piston ring job must be done or engine replaced
What about the camshaft sensor
That is not the first thing I would check and I’m not sure it will cause same problem, simply I haven’t seen that happen
I had a code for camshaft position sensor, no start issue. Replaced it and no longer have the code visible but still no start.
Your vedio you mention this might be. I feel you need to mention the engine components by name so that we will know were you coming from otherwise thanks for the vedio
I think the last time I checked I found out that I don’t work for you , you need to teach yourself some manners , respect and appreciation, be thankful that someone made all that effort to make this vedio possible , people like you who made me stop posting more vedios . You don’t deserve my time and effort.
Pho Q , i don’t work for you ,
Endo de va?
Did your car turn over and start up sometimes, or was it just dead. My sometimes takes a long time to start. Any ideas have to crank motor for 30 to 40 seconds to start . It is to fire right up
My car would just crank but never starts till I replaced the crank sensor
Was your issue crank sensor?
No they said at Audi that it jumped timeing, but now my chk. Eng. Light just came back on but the car works good
@@lizards7777 so it jumped timing was that easy fix can it turn on ?
@@strictlyaudis7012 I need some help on Audi a 4
It doesn’t generate power it only interrupts power
Car cranks and runs but only for 10-15 minutes??
Hi m having samw problem did you find any solution
Did you ever figure out what it was ? @viper.
Similar problem but my solution was that my EFI and ECM relays were bad.
What’s the Efi relay ?
Fuel pump relay ? 70 amp?
It's a common problem that the seal breaks or gets missalligned on the ECM box and water gets into the box which will kill the two relays under the computer. I had this problem and had to swap relays multiple times because of water kept getting into the box, sealing the box properly is not the easiest so I suggest finding a new lid with seal. Eventually i had to swap out my ECM as it was water damaged.
☝☝☝☝☝👏👏👏👏👏
It’s OBD 2 not 11 and saying this in good sense, not to make fun.
I totally get it but this is OBDeleven ultimate , it’s called that way . It’s made in Lithuania , there is starter, basic, pro and ultimate. And it’s called OBDeleven. Type this word in your phone and you’ll see the app :) I’m saying this to you in good sense as well not to make fun of you. Thanks for watching , the vedios that are coming next will be really good ,
Thenk you
Hey, I would like to know what Pxxxx code you got with OBDII, got the problem 3 days ago with 1.8T 225HP my daily, and it was starting right for 5 minutes in the morning , turn off and it won’t start after all later!
I don’t really remember but the code sent me directly to the crank sensor , Try to put a new crank sensor to see if the problem is gonna go away . Also see if the rubber tube coming out of turbo if open or cut , if it’s open the car will crank but won’t start
@@jimmyjames8164 I know that but I have so many cars in my OBDeleven scanner and sometimes finding the right one is a hustle
P0016