How to fix Poor running BobCat that loses power

Before you go sending out your Bob Cat skid steer loader to the dealer for service, save yourself time and money by doing this simple fix first. Rob shows you a technique that fixes this Bob cat T140.

[@jbeech01]

Very helpful. Well done. Thank you!!

[@sectorclan06]

Thank you so much.Feel filter.Was dirty.I almost send to the dealer.

[@Lllihgcd]

I appreciate the video I think you might have just solved my problem!

[@jasonredepenning]

Cute little bobcat.

[@ezbuilding]

Great video and advice should solve my problem… many thanks!1

[@moejoe5016]

Thanks. To the point . Simple

[@eastky1901]

Yea, I push my throttl to go at high rpm, then the throttl will move itself back to idle. Might just need to tighten the throttl cable, have more friction to hold it in place...., anyway, I'm gonna change my filter, just like you did, and also clean under the cab, and hopefully the thing will keep working. It's old. 93 model bobcat. Forward goes alot slower than backwards. Idk if you may know how to fix that? Ty

[@raylarie]

Very good thank you. Can you do a video on replacing the alternator on a 2007 s 130?

[@robsarauskas3396]

So, what will happen if the bobcat runs with the purge valve still open? Low power?

[@vincentstormsj]

Won’t built up pressure and run rough ?

[@bobcat8439]

Doing the same thing napa too

[@pilarcortez3707]

Nice video I've th t550 no throttle could be the same problem

[@mannyfresh8612]

I have a problem with my 2004 bobcat T250 I get a code where it says Hydraulic Charge Pressure in Shutdown and it turns off I have replaced the oil pressure sensor the belt the Main Hydraulic Pump and the gear pump I have no oil leaks and still does the same code and shuts off and also the fuel injection pump

[@youtubemechanic]

Interesting. Ninety percent of the time it's the belt broken or the tensioner pulley. And your hydraulic oil level is good?

[@mannyfresh8612]

Yes I replaced the pulley aswell and hydraulic level is good

[@scrhino40]

Thats not my problem. Change fuel hydraulic filters and still bogs down while turning abd using lift arms and bucket tilt.

[@jakekehn9915]

@scrhino That’s the problem I’m having what did you do