How to change clutch plates on a Honda CBR 954rr

Hi.
If you have seen my motovlog #10 you would know that I fucked up my clutch plates. So, a brand new tutorial on how to change clutch plates on your Honda CBR 954rr became obvious.
In this tutorial I will be changing the clutch plates, springs and gasket. Below you'll find info on working order, tools and torque settings.
Enjoy!
Working order:
1. Make sure you have all the replacement parts ready (show the parts)
2. Place new clutch plates in engine oil for one night.
3. Place two pieces of wood under the front and rear tire (so that the angle is sharp enough and you do not have to drain the engine oil)
4. Disassemble right fairing panel
5. Disassemble clutch bracket and cable
6. Remove cover
7. Disassemble clutch plates (friction plates and plain plates)
8. (optional: measure thickness of friction plates, warpage of plainplates and the free length of the clutch springs)
9. Replace old for new (note the right order and last friction plate has green marker so be sure to place it in right way!)
10. Install new clutch springs
11. Replace new gasket (I used Loctite 574)
12. Install cover
13. Install right fairing panel.
Torque settings:
• Clutch spring bolts: 12Nm
• Bolt cover: max. 10 Nm
Tools you will be needing are the following:
• Allen key: 5 (metric)
• Ratchet: 8 & 10 (metric)
• Torque wrench: 8 & 10 (metric)
• Vernier caliper
A workplace manual would come in handy.
Leave a LIKE if you enjoyed the video. Consider SUBSCRIBING, it helps a lot :)
/ @dutchiedoes
Bikes:
- Honda CBR 954 rr Fireblade (2002)
Options: • Dutchie Does #3 - Hond...
- Honda CB550 Four K3 (1978)
Not yet in use for motovlogging while I'm restoring this bike.
Vlogging equipment:
- GoPro Hero 4 Black (helmet mount)
- GoPro Hero 1 (left hand mirror mount)
- mic: cheapest shit available but works fine