Manual Machining Custom T-Nut Reverse Hold Downs
ฝัง
- เผยแพร่เมื่อ 23 ก.พ. 2024
- If you have ever had to machining the entire surface or perimeter of a plate you have likey ran into an instance where the hold downs or clamps are in the way. These little guys screw into a threaded hole in the plate only .250" deep and leave the rest of the plate free and clear to be machined. Full disclosure I am not claiming to have invented these, I am sure you can buy them somewhere, I am just impatient....
Join this channel to get access to perks:
/ @519kustomz - ยานยนต์และพาหนะ
I enjoyed learning how you made the T clamps and showed how useful they are. Out of curiosity, what was the end product to be used for?
Thanks! End part is just some exterior trim for car project