Xbox Elite Controller Series 2, Left Joystick replacement 【🗺️ACTIVATE SUBTITLES】

I use a normal potentiometer.
-----------------------------------------------------------------------------------
00:20 Using: spudger (plastic pry tool).
00:28 Pry the lid.
00:49 Open the lid.
01:13 Unscrew 6 screws. [T8 security screw].
01:55 Pry the back lid.
02:09 Separate the back lid.
02:21 Using: any masking tape.
02:28 Glue the vibrators.
03:44 Using: "FLUX paste".
03:56 Apply: "FLUX paste".
04:17 Desolder right vibrator.
04:49 Desolder left vibrator.
05:13 Using: T6 screwdriver.
05:24 Remove 2 screws. [T6].
05:38 Remove the right joystick cover.
05:52 Left joystick damaged.
06:14 Disconnect the wireless antennas.
06:39 Disconnect the logic board.
06:42 Remove the audio jack.
06:44 Take off the logic board.
07:27 Using: aluminum tape.
07:45 Glue the aluminum tape.
08:45 Seal the aluminum tape.
09:19 Using: "FLUX paste".
09:27 Add "FLUX paste" to the pins.
09:40 Desoldering the joystick.
09:56 If you can't absorb the solder joint, you can help yourself with air hot gun at 400°C.
10:29 Pull down the joystick heating it at 380°C.
11:10 Clean the surface from "FLUX paste".
11:41 Remove "FLUX paste" residues.
11:55 Showing the old and new joystick.
12:18 Install the new joystick.
13:00 Clean the fine soldering tip.
13:18 Using: fine solder wire 0.3mm.
13:31 Apply "FLUX paste" to solder wire.
13:41 Soldering the joystick pins.
15:21 Apply "FLUX paste" as it was necessary.
15:24 Soldering the joystick pins yet.
15:37 Clean the soldering iron as it was neccesary.
15:43 Soldering the joystick pins yet.
16:15 Clean the surface from FLUX residues.
16:43 Install the audio jack.
16:51 Insert the logic board to the frame.
19:16 Solder right vibrator.
20:09 Solder left vibrator.
21:40 Screw the 2 screws. [T6].
22:10 Accommodate the cable's vibrators.
22:20 Close the back lid.
22:31 Test the buttons.
22:47 Insert the right joystick cover.
22:52 Insert the left joystick cover.
23:12 Screw the 6 screws. [T8 security screws].
23:44 Close the lid.
23:55 I tested without xbox console at www.gamepadviewer.net
Music: audionautix.com/

[@slangerfps2854]

thanks for the sound on the video it really helped a lot

[@nicg3288]

Jesus, it was way easier on the N64 controller! They really don't want people to change it by themselves... Thanks for the video anyway, It's very detailed!

[@akarshanmishra2351]

You can’t adjust the tension on the left stick now right ?

[@centrodeserviciopueblamx5727]

I can't, so I replaced.