Oil Pressure Sensor - Chevy Impala

How To Replace The Oil Pressure Sensor In A Chevy Impala 2006 - 2013. This Will Fix Low Oil Pressure Shut Off Engine Light Code in your Chevy Impala. #whojoedaddy For more DIY and How To Videos; Hit SUBSCRIBE, LIKE and Leave a COMMMENT to let me know if this helped you.
Disclaimer:
Due to factors beyond the control of WhoJoeDaddy, I cannot guarantee against improper use or unauthorized modifications of this information. WhoJoeDaddy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. WhoJoeDaddy recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of WhoJoeDaddy, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not WhoJoeDaddy.

[@Will-vl7cb]

Thank you for the video!! Made this easy

[@WhojoedaddyDIY]

Great!

[@danblumel]

I did it from both the bottom and the top, removed the 3 exhaust heat shield screws and 3 screws on the plastic shroud under the car for bottom access.
Much easier to disconnect the connector from the sensor from the bottom & easier to get the socket on the sensor from the bottom. Once I had the socket on it, I inserted the ratchet with long extension onto the socket & removed the old sensor. There is a silicone rubber seal that should stay on the power connector, but it may stay in the old sensor when removing the connector. Make sure to reuse the seal back onto the connector if that happens (mine was yellow colored). One more note, it was difficult to get the new sensor started into the threads (I'd say almost impossible from above with my arms). It also seems to be canted upward slightly so a bit tricky to get it started into the threads, thinking it's mounting is exactly perpendicular. This also made reinsertion of the connector also a bit tricky before it could be fully inserted. The job took me 2 hours learning these "tricks". If doing it a 2nd time, only about an hour or so.

[@WhojoedaddyDIY]

Nice job! 👍

[@user-ol4dg1uj7g]

O it p} pp}}}

[@the2pachistorian591]

Great video

[@WhojoedaddyDIY]

Appreciate it, thanks

[@Bighead-np9wx]

Love your name woah joe daddy

[@WhojoedaddyDIY]

Thanks, started off as a fantasy football name and kind of stuck. lol

[@justrealtooraw1981]

Thanks for the tutorial. I just got this warning last night. So now that I know how to do it, will be taking care of this either today or tomorrow. Thank you.

[@WhojoedaddyDIY]

@@justrealtooraw1981 glad you found it helpful, good luck! 👍

[@taiwojenty4485]

What could cost my car oil light turn on and turn off immediately why driving ?? Can someone explain

[@WhojoedaddyDIY]

Would need some more information, but if one of my girls called me with this problem, I would want them to double check that it has the proper oil levels until I could figure out why the light was coming on. Sounds like it could be the oil sending switch unit. Light would go out after you build engine oil pressure when driving.
Check out this forum, believe it might give a better explanation. Good luck!
www.impalaforums.com/threads/oil-pressure-low-warning.1874283/