Case 580K Extendahoe Removal

This is a slide show overview of a Case 580K extendahoe removal and hydraulic fix due to a loose gland nut and worn hydraulic lines. Step by step instructions can be found in the Case 580k repair manual, but having read it, are not particularly useful because it uses vague part descriptions, does not include all steps, and has some unhelpful steps like 'put backhoe on a flat surface'. Hey, come along and enjoy the show!

[@darrelldohrwardt7754]

Great video, I’m still trying to my 2.5 rod by 3.5 cylinder dipper piston nut off. I got the seal kits for entire boom, just trying not beat up my chrome or fingers! Don’t forget the hoses!!

[@NineCarGarage]

The hoses are the worst and very expensive. If I was braver, or had a swagger, I'd make them myself. About that bolt, add heat!

[@Trumpistoast2024]

Thanks for the tips!

[@krisv8407]

Good stuff bud

[@Eddlemon08]

Where did you get the manual thumb from? I’m needing one. Thanks

[@NineCarGarage]

Titan attachments. See my other video for more info!

[@labla8940]

Do you have a section where the extenda hoe retraction hose (bottom hose xtendahoe) from valve body how its routed? I had someone remove it and cant figure correct routing

[@NineCarGarage]

I have the workshop manual and can take a video of the route if you still need it

[@labla8940]

@@NineCarGarage hank you that's generous I think I routed. it wore out originally at the coupled end at the 90 coupler I think it was replaced before and installed wrong as it wore down through at that spot. I have 1000+ page manual but its more for rebuild and has exploded view Its PDF on my PC. I couldnt figure it out there I am not even sure I am reading it correctly. If its not to much trouble I would appreciate that