He just wants to make it so he can out it back it it's original state, though I would have liked to see him cut a silt out of the bottom edge of the plate or a hole.
آپکی ویڈیو پسند آئی. معلومات مین اصافہ ہو. ابکی📼 مینے جون میں دیکہی۔ میں جب بہی آپکی ویڈیودیکتا ہو. وہ دو ماہ پہلی کی ہو تی ہے۔ 🆕 ویڈیو لوڈ ہونے کے بعد رابطہ ہوگا۔👍👋🔚🌻⭐..
Is it okay make a hole on that battrey module? Wht kinda cable that used in video? How much time to charge? How i know the batteries is full because phone just recognizes the battery is only one conected? It works right?
Battery charge percentage that you see on your phone is based on a few factors but in simple terms it depends on the voltage between the battery terminals. All phone batteries have about 3.3V when discharged and 4.2V when fully charged. That's your 0% and 100% charge. You can have 2, 5 or 100 batteries connected in parallel (assuming batteries are identical) and they will have the same voltage across. Since you are doubling the capacity, you can go about twice as longer without needing to recharge. The only way to go over 100% charge is if you connect the batteries in a series, in which case (3.3 + 3.3) 6.6V empty and (4.2+4.2) 8.4V full. Which is too high and surely damage your phone.
Boss my phone have 3 .7 volt 2900 mahbattery so and 1more battery same and that will be become 3.7 volt 5800mah now can run lenevo k3 note phone on both battery parallel way like u have run please comment if problem than please comment and help me your viewer it will helpful for me
Wtf, you just connected two different capacity batteries in parallel. One battery will over charge other battery, it will get too hot, and explode. It's a bomb Don't follow this video.
Absolutely not. The only way for this to happen is for the motherboard to request more than 3 ~ 4 amps of the battery, which is impossible for a cell phone and even tablets. The only way this could happen is if the board are shorted.
Haalo, i put a 3400mah other phonw battery, on my c5ultra but it only shows 2930mah. But it last a lot longer. Any idea on how to make it shows 3400mah???
@@tankiman3489 you'll need to jailbreak for that, the apps I use are only available for Android, but if you jailbreak, you can find an app called "battery life" and that will allow you to reprogram the battery by adding capacity and then cycling the battery
Im using Hauwei y9 phone it's Batt is 4000mah, I want to upgrade my Batt to about 5000mah and I want to use jus one battery in my phone can I use a different phone battery that is 5000mah in my phone but I will have to exchange its BMS will this work, pls anybody?
I still have the s4. Aftermarket parts are very cheap these days. Charging board from china are $3 at most. Edit: i have tried the double battery on the s4. Its actually easy. You stick the same s4 battery on top of each other. Then bridge the contacts on both batteries. Look it up on xda, you will find some pic examples
Does not work because.. iv done this I know Maybe it's the virson of android I used But once you charge the phone it only recanise the original battery So 100 on the battery is split 5050 At one present the phone thinks it's dead and will turn off regardless
it's parallel, when each battery has voltage as required for inputof phone, you add in parallel. When you want to double the voltage, you add in series. E.g. in flashlight, you can use 3 AAA batteries of 1.5V each in series, to get 4.5V.
![LISA - NEW WOMAN feat. Rosalía (Official Music Video) reaction [NEW LEVEL!]](http://i.ytimg.com/vi/BcppQEBJzEA/mqdefault.jpg)
This should go over well through TSA airport inspections
Much better if you make a hole in your back case for the wire.
I was going to say that
He just wants to make it so he can out it back it it's original state, though I would have liked to see him cut a silt out of the bottom edge of the plate or a hole.
i was thinking about that
Exactly my thoughts
Yes
Next time removing that silicon is not easy. It will get messy
آپکی ویڈیو پسند آئی. معلومات مین اصافہ ہو. ابکی📼 مینے جون میں دیکہی۔ میں جب بہی آپکی ویڈیودیکتا ہو. وہ دو ماہ پہلی کی ہو تی ہے۔ 🆕 ویڈیو لوڈ ہونے کے بعد رابطہ ہوگا۔👍👋🔚🌻⭐..
me:*makes xtra battery for phone*
!!!!!!!!!!!!
phone:!!!BOOM!!!
!!!!!!!!!!!!
Is it okay make a hole on that battrey module? Wht kinda cable that used in video? How much time to charge? How i know the batteries is full because phone just recognizes the battery is only one conected?
It works right?
Actually.. it reconizes both but doesnt show 200% since the other battery will keep suplying the main battery it will stay at 100 for some time
Battery charge percentage that you see on your phone is based on a few factors but in simple terms it depends on the voltage between the battery terminals. All phone batteries have about 3.3V when discharged and 4.2V when fully charged. That's your 0% and 100% charge. You can have 2, 5 or 100 batteries connected in parallel (assuming batteries are identical) and they will have the same voltage across. Since you are doubling the capacity, you can go about twice as longer without needing to recharge.
The only way to go over 100% charge is if you connect the batteries in a series, in which case (3.3 + 3.3) 6.6V empty and (4.2+4.2) 8.4V full. Which is too high and surely damage your phone.
My 5k mah Mobile btry bms handle 10k btry 3.7 v
I want to upgrade
My 5k mah Mobile btry bms handle 10k btry 3.7 v
I want to upgrade
My 5k mah Mobile btry bms handle 10k btry 3.7 v
I want to upgrade
2021, still working?
Very helpful 👌👌
How many time to take full charge
Boss my phone have 3 .7 volt 2900 mahbattery so and 1more battery same and that will be become 3.7 volt 5800mah now can run lenevo k3 note phone on both battery parallel way like u have run please comment if problem than please comment and help me your viewer it will helpful for me
What if you just change the bms from one to another but pun a battery withh more capacity that fits there
better use power bank. this should has balance battery
It can give more backup but while charging It can damage the charging ic.
Wtf, you just connected two different capacity batteries in parallel. One battery will over charge other battery, it will get too hot, and explode. It's a bomb
Don't follow this video.
Absolutely not. The only way for this to happen is for the motherboard to request more than 3 ~ 4 amps of the battery, which is impossible for a cell phone and even tablets. The only way this could happen is if the board are shorted.
They are in parallel **
in 0% both baterry has 3.3v and when 100% bo5h battery has 4.4v?
@@farikkun1841 Normally 100% is 4,2v - 4,35v Max, 4.4v is too high; Min about 3,3v- 3,4v.
@@gabrielgomesdossantos5244 could you please say what is the name this wire?
Should have just cut the battery cover for the wire to pass to avoid using silicone.😊
Excellent job
Genial colega me gustaria muchos pudieramos hacer esto con los moviles
Does it work for samsung phones
Hacker 😎📱
Amazing
Haalo, i put a 3400mah other phonw battery, on my c5ultra but it only shows 2930mah. But it last a lot longer. Any idea on how to make it shows 3400mah???
I think this battery info is kept in some files or firmware and only with root you can access them.
Download accu battery and you can change the design capacity
I wanna do it to my iPhone. But donno how to do it.
@@tankiman3489 you'll need to jailbreak for that, the apps I use are only available for Android, but if you jailbreak, you can find an app called "battery life" and that will allow you to reprogram the battery by adding capacity and then cycling the battery
@@tankiman3489 th-cam.com/video/HEqQ9S04ki8/w-d-xo.html&feature=shares try this one my friend
Any disadvantages
It looks ugly
@@markjarvillemartin4228 😭
Im using Hauwei y9 phone it's Batt is 4000mah, I want to upgrade my Batt to about 5000mah and I want to use jus one battery in my phone can I use a different phone battery that is 5000mah in my phone but I will have to exchange its BMS will this work, pls anybody?
I have s4 With charge Port broken any tip for for direct battery charge with dual like this?
I still have the s4. Aftermarket parts are very cheap these days. Charging board from china are $3 at most.
Edit: i have tried the double battery on the s4. Its actually easy. You stick the same s4 battery on top of each other. Then bridge the contacts on both batteries. Look it up on xda, you will find some pic examples
save....🙏
Does not work because.. iv done this I know
Maybe it's the virson of android I used
But once you charge the phone it only recanise the original battery
So 100 on the battery is split 5050
At one present the phone thinks it's dead and will turn off regardless
I want to make it with old mobile does it explode please help
I did a similar mod to my galaxy s10 plus, now it has 14,000mah
Really ? How many days does full charging last?
@@tankiman3489 I can reliably get 2 days out of it
isnt s10plus has original 4100mah battery? what additional battery u use?
@@farikkun1841 the 10+ is only 4000, I used a 10,000mah cell to boost the capacity
@@mwbgaming28 Only 2 days from 14000mah battery?!
with what kind of usage?
How to connect 3 batteries together? I tried 2 and it worked but every time i try to connect the third one it burns
Make sure all of them have the same charge. If one of them is lower or higher, the current inrush will cause the wires burn
imagine playing games
U better cast a resin compound on it
Buat lubang aja atau pakai kabel yg tipis
Now I know I'm not the only one who made that hahhhaha😂 where the same only mine have the second batterryis bigger
Did it work
I think hes lying thats why he didnt respond
I made too hahah
Of course that words.
He's not lying, that's possible
8hour charging 😆😆😆😆😆😆
Chaging time duble battery
I have a s5 with a s7 battery on the back 😂😂😂😂😂
Can you show me how i can attach a 5000mah cell to my galaxy s4? Have you video or site to indestand the mod. thanks
But it is still showing 2930 mAh.
don't you have to change capacity in floating_features after changing the physical capacity?
All this just for five hours of playback?
This is not series circuit.
it's parallel, when each battery has voltage as required for inputof phone, you add in parallel. When you want to double the voltage, you add in series. E.g. in flashlight, you can use 3 AAA batteries of 1.5V each in series, to get 4.5V.
not fucking bad..mmm
Hi
Sike
boom?
I Will not
👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍
Its ok but How Can charge Fast
I think this idea
are you mad bro
copy video
poor design and my phone can stay up to 4 hrs without any extended battery in youtube video playback
its fake
How is this fake I made one