How to Replace a Maytag Electric Dryer Push-to-Start Switch

This video from Sears PartsDirect shows how to replace a broken push-to-start switch in some Maytag electric dryers. If your dryer won't start when you push the button, or if it starts when you close the door without pushing the button, you might need to replace the push-to-start switch.
Visit us at
www.searsparts...?sid=soc:youtube:how-to-replace-a-maytag-electric-dryer-push-to-start-switch
Or call 1-800-437-1673 to speak with a parts specialist.
The video includes these parts. Look up your model to make sure you get the right parts for your dryer.
Push-to-start switch
www.searsparts...
Find parts for your dryer at:
www.searsparts...
Or click here to schedule an appointment with a repair technician.
www.searshomes...
Transcript:
The push-to-start switch completes an electrical circuit to start the drive motor and begin the drying cycle. If the electrical contacts in the push-to-start switch fail, the dryer either won't start when you push the button, or it starts when you close the door without pushing the button. If the push-to-start switch fails, replace it with a manufacturer-approved replacement part. Before you begin. Wear work gloves to protect your hands. Unplug the dryer. Pull the control knob off of the front of the push-to-start switch. Move the dryer forward and use a 1/4" nut driver to remove the screws from the back panel. Remove the back panel from the dryer and set it aside. Note the location of wires attached to the back. Label the wires or take a digital picture so you know how to correctly reconnect them later. Then remove the wires. Release the locking tab and slowly rotate the push-to-start switch while pulling it, to release it from the control panel. Push the new switch into the panel and rotate it to lock it in place. Attach the wires on the back of the push-to-start switch, following the labels or digital photograph. Warning: For safety and to avoid damage to the new switch, the wires must be properly connected. Position the panel on the back of the console. Line up the mounting screw holes, insert the mounting screws and tighten them firmly. Push the control knob down on the stem of the new push-to-start switch. Plug the dryer into the wall outlet.

[@buddyclem7328]

If your switch rotates out of place like mine, pull gently on the knob while slowly rotating left and right until you feel a click. Test the dryer to see if it will start now. My switch was probably loose since the dryer left the factory.

[@BrendonComposer]

Thank you so much for this! This took care of it!

[@kristincomeau4473]

Thank you!!! Saved the day :)

[@FlamingoVlogs]

My Maytag dryer I was about to kill it with a .45 but I took off the fuse and connected directly and it worked !!! fuse discontinued

[@wilfredo312]

better ti rhrow it waste of time