Maxfun 10 Pro Scooter - Changing P Settings & Creating a Custom PAS 1 Power Level

In this video, I show you how to access the P settings menu, as well as create a custom PAS 1 power level for your maxfun 10 pro electric scooter.
Once you have tweaked the PAS 1 settings to your liking, you can just power on your scooter and go without having to switch the PAS level first every time. It makes riding so much more convenient.
#maxfun

[@WyomingRider]

Great Job!

[@OneBarLeft]

Thanks. More maxfun content coming soon.

[@kemle]

PSA: if you want to change any of the three (3) PAS profile's speed, power, e-abs, etc. You must first be on the PAS number you want to adjust on the "Main" screen before going into P4 -> Advance (+ & - button).
In my case, I reversed my settings from 1 being fastest and 3 being the slowest as whenever you turn on the scooter PAS 1 is the default when turning on the scooter.
Hope this helps.

[@OneBarLeft]

Thanks for the information 👍

[@WyomingRider]

I'm still struggling with the front brakes. I tried the paper method you suggested and I found I couldn't at first. There wasn't enough space to get the paper in there folded even if I pushed caliper in as far as it would go with the bolts loosened. I've tried 3 different sets of brake pads. I added a couple extra washers to add extra spacing so i could fit the paper in, but it still squeals. I did notice when i took the last set of pads off there only seemed to be wear at the top and the bottom of the pad. Like nothing in the middle. Any other suggestions?

[@OneBarLeft]

That’s strange that only the top and bottom would show wear. That was inside and outside pads both? Wish I could post a photo in the comments section of my pad to rotor gap.
Edit - sent you an email.