10/22 Receiver drilling cleaning rod hole
ฝัง
- เผยแพร่เมื่อ 20 ต.ค. 2024
- Showing the use of the Cleandrill™ Tool. Tool is designed to effortlessly drill a hole in the rear of the 10/22® Rifle receiver. This allows the use of a cleaning rod thru the rear of the barrel when the bolt is removed from the gun. Tool is manufactured by, and is available from gunsmithertools... ,
and from midwayusa.com
This is pretty cool might have to order one, I've considered doing this for years but like this way better than eyeing it
Love it. I have used it on four 10/22s.
Indeed my friend, but nothing beats a brush for chamber and throat cleaning in my experience, hence the cleaning rod hole in the rear.
Great idea👌🏻
Quick question: How does one go about removing the barrel breach? Heat receiver in the oven?
If you have a Ruger factory barrel, they usually come out easily. Remove the two screws that hold the "V" shaped barrel retainer block, and the barrel should come out. A tight fitting aftermarket barrel may not come out easily,
and may require some heat on the receiver; use a hair dryer to heat the receiver to remove a tight barrel.
you can always use a bore snake to clean the barrel
Once a bore snake gets dirty you just end up pushing that dirt down the barrel. A good brush will give you a cleaner rifle.
It is 3/8" in diameter.
No the hole will be covered by the stock, and the chamber would be open immediately after firing.
How do you change the bit in the extension?
You don't. The drill bit is a very high quality bit, and will stay sharp for many hundreds of holes in Aluminum. Use a little WD-40 or cutting oil to lube it.
NO worries about possible blow back past the bolt and out that hole into your eyes?
Someone never heard of a bore snake lol
Holy over complicating things!!!
Good idea, but I can't believe people actually think they need that to make that hole.
Ridiculous.
hmm, the ww. address didnt work. did you mean three w's or just two?