can i ask how bad was your oil leak? I have 01 s4 and i thought my oil pan was leaking but with further inspection i found the leak coming from the rear of the engine on the driver side also leaks on top of the exhaust
There's no need to remove the erg valve, or loosen the heat shield to replace the drivers side cam cap seal. I just replaced mine yesterday, and after struggling in the attempt to remove the erg, I said heck with that and just removed and replaced the cap with it in. It's tight, but easy enough to replace. The passenger side erg was removed, but that side is a piece of cake. Tip: For easy of replacement, put the new caps in the freezer. Pressing them in is a breeze when they are cold.
It's not the egr, it's the secondary air valve, and yes it is necessary to remove it. the plug is partially covered on by this secondary air valve on the driver's side.
Thanks to you I didn't need to take either erg valves off. Just a lol prying with my fingers loosen them both and then tapped out with long flat head screwdriver and hammer did the trick💃🏾💃🏾💃🏾💃🏾💃🏾😊👍🏿
reallly appreciate this video as i am about to leave on a trip to colorado and want to take care of this leak. i have a whole gasket kit from blauparts that includes the cam caps. just haven't got around to getting the whole job done. i think i'll try to replace these caps myself later today. thanku!!!
Hi Nicole. yes cam seals might be the culprit. drive the car for a few minutes and then check for leaks behind the head,you might have to remove the coolant tank to see better.
cam plugs and valve cover / cam chain tensioner seals all tend to leak. Cam plugs are easier to change and cheaper, so I'd suggest doing those first. If you still have issues with oil leaks, then do the valve cover gaskets and camchain tensioner seals.
I just replaced my valve covers but it still gives me smoke underneath the egrs.. So you think it could be my cam chain tensiorners? Or could it be my cap seals?
I see the burning smoke coming from my passenger side rear of engine by the valve.... I'm guessing its the cam seal on that side leaking on to the exhaust and burning.. Sucks that I didn't see your video before because I already took off the valve cover haha.. I don't have the camshaft chain tensioner tool to do the half moon and tensioner seals so I'm just going to the cam plugs and see what happens.
nice diy. egr is not necessary though just followed this vid to do mine and couldn't get in there to remove egr bolts :/ just pried them out from the side. also didn't remove coolant hoses just the three screws and pushed it aside.
Yes you can replace both sides without removing the engine. On the driver side you have to remove a few more things than the passenger side but it’s not too difficult.
@@mannysolution Man thank u Mr. Manny I purchased this car and the only problem im having is the oil burning smile took it to get it checked out and the guy quoted me $3000 I didn't even pay that much for the car. Lol
![[ ออกกอง ] วัยหนุ่ม 2544 โลกหลังลูกกรง..ทัวร์กองถ่ายหนังใน "คุกของจริง" | JUSTดูIT.](http://i.ytimg.com/vi/vB--aOkZCpw/mqdefault.jpg)
I'm glad this video helps people.it's been 2 years since I made it and i haven't had any oil leaks ever since.
can i ask how bad was your oil leak? I have 01 s4 and i thought my oil pan was leaking but with further inspection i found the leak coming from the rear of the engine on the driver side also leaks on top of the exhaust
There's no need to remove the erg valve, or loosen the heat shield to replace the drivers side cam cap seal. I just replaced mine yesterday, and after struggling in the attempt to remove the erg, I said heck with that and just removed and replaced the cap with it in. It's tight, but easy enough to replace.
The passenger side erg was removed, but that side is a piece of cake.
Tip: For easy of replacement, put the new caps in the freezer. Pressing them in is a breeze when they are cold.
It's not the egr, it's the secondary air valve, and yes it is necessary to remove it. the plug is partially covered on by this secondary air valve on the driver's side.
Thanks to you I didn't need to take either erg valves off. Just a lol prying with my fingers loosen them both and then tapped out with long flat head screwdriver and hammer did the trick💃🏾💃🏾💃🏾💃🏾💃🏾😊👍🏿
superb clip .... that burning oil smell, now magically gone, on my 2000 Audi 2.7T. Replaced both of them, on back side of engine.
Can I replace both of them with out taking the engine out.
Can I replace in my car with out taking the engine out.
@@marcharris3413 yes.
this is the only video on this i could find... super helpful thanks man
reallly appreciate this video as i am about to leave on a trip to colorado and want to take care of this leak. i have a whole gasket kit from blauparts that includes the cam caps. just haven't got around to getting the whole job done. i think i'll try to replace these caps myself later today. thanku!!!
After changing the camcap seal, no more oil leaks no more burning oil smell.
Can I change both with out taking the engine out.
Thanks for the video✌🏻
Hi Nicole. yes cam seals might be the culprit. drive the car for a few minutes and then check for leaks behind the head,you might have to remove the coolant tank to see better.
cam plugs and valve cover / cam chain tensioner seals all tend to leak. Cam plugs are easier to change and cheaper, so I'd suggest doing those first. If you still have issues with oil leaks, then do the valve cover gaskets and camchain tensioner seals.
I just replaced my valve covers but it still gives me smoke underneath the egrs.. So you think it could be my cam chain tensiorners? Or could it be my cap seals?
Nicole Cluff did you ever find the issue? Could be rocker cover gaskets.
It either chain tensioner or half moon seal
I see the burning smoke coming from my passenger side rear of engine by the valve.... I'm guessing its the cam seal on that side leaking on to the exhaust and burning.. Sucks that I didn't see your video before because I already took off the valve cover haha.. I don't have the camshaft chain tensioner tool to do the half moon and tensioner seals so I'm just going to the cam plugs and see what happens.
Sweet...thanks for posting!
When you removed the egr valve, did yours have gaskets? I removed my passenger side, however, had an exhaust leak, but never noticed a gasket. Thanks.
Yes it has a gasket between the cylinder head and the EGR valve. It usually stays stock to the cylinder head when you remove it.
@@mannysolution thanks, I appreciate it
nice diy. egr is not necessary though just followed this vid to do mine and couldn't get in there to remove egr bolts :/ just pried them out from the side. also didn't remove coolant hoses just the three screws and pushed it aside.
Your welcome thanks for watching.
Can I replace the right side with the motor still in.
Yes you can replace both sides without removing the engine. On the driver side you have to remove a few more things than the passenger side but it’s not too difficult.
@@mannysolution Man thank u Mr. Manny I purchased this car and the only problem im having is the oil burning smile took it to get it checked out and the guy quoted me $3000 I didn't even pay that much for the car. Lol
@@mannysolution whats a good price for this work I got a freind who said he can do it and looking at ur video hell im convinced that I can do it.🤣
Its my first foreign car and I really do like it.
Sorry for the inconvenience im n Oceanside Callifornia so wasn't quite sure where u at but thank u so much for ur responses.
Lol my question is and will forever be...why do these exist!? 🤣
It’s just another part they can sell to us!!!! 😂
@@mannysolution Lol exactly. You know what it is 😂