ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
Will your indicator be accurate when positioned on the angle of the mill?
@@bradwiebelhaus7065 should be. As long as the arm of the DTI is parallel to the travel of the table, any slope on the table at the point of contact is irrelevant. I'll let you know when I've drilled the holes 😁
Move the DTI pin to the centre, above the screw? There`s not much holding your piece "neither! A rotary dividing head would be safer than that.
@@brianeustace4175 all done now.. Worked a treat.
Yes I did, you wrote either, instead of neither
@@raymondsanderson3768 someone else said that too 😁
Will your indicator be accurate when positioned on the angle of the mill?
@@bradwiebelhaus7065 should be. As long as the arm of the DTI is parallel to the travel of the table, any slope on the table at the point of contact is irrelevant. I'll let you know when I've drilled the holes 😁
Move the DTI pin to the centre, above the screw? There`s not much holding your piece "neither! A rotary dividing head would be safer than that.
@@brianeustace4175 all done now.. Worked a treat.
Yes I did, you wrote either, instead of neither
@@raymondsanderson3768 someone else said that too 😁