Spa Guy How To Series Heat.wav-XE IN.YE Gecko Aeware Basics and Diagnostics Heat.wav

Click this link for the heater in this video: hottubpartsofamerica.com/heat...
In this Video The Spa Guy shows You How To Do some basic diagnostics on the Heatwave-Xe Heater and some other information.. Like, Share and Subscribe..
#spaguyhowto

[@ts4x4jeep]

I have this exact controller, and it has a red light in the bottom right corner is the light supposed to be on?

[@jphill2121]

Is there a way to test the flow sensor? I"m getting a Flo error. Did all the standard troubleshooting and replaced the circulation pump. Next is the heater or the board. Trying to eliminate one or the other.

[@shannongrettenberger6399]

Same question- replaced circuit board. Jets don’t run until water is at desired temp. They run for the 20 min and then shut off and give me FLO error. It does heat up at degree or two for the 20min

[@forrestkutyna6048]

any luck on getting part number for the flow sensor?

[@spaguyhowto7417]

To my knowledge you cannot buy the water sensor or temp sensors outside of the complete heater..