Hey man I have a 2012 Rzr 800, I had A LOT of slop/play between the ball joint and the spindle. I’ve ordered replacement parts for both but I cannot find the exact pinch bolt I’m suppose to use. Do you have a part number or the exact size or anything that can help. Any info is appreciated thank you !
Here is the diagram for the front arms. Not sure which bolt you are referring to. www.partzilla.com/catalog/polaris/side-by-side/2012/rzr-800-efi-eps-r12vh76ab-ad-af-ah-ai-aj-am-eab-eas/suspension-front-control-arms
i am rebuilding a Yamaha tt600 1983 and it has piston slap i measured the bore and its in speck and the piston is too, there is not any bent con rods but the bottom end bearing arnt the best what can i do?
Super helpful. I just realized my upper ball joint had some slop and this task looks easier than i anticipated. Thanks for making this video
Man your shop is as clean as a hospital OR!! Great videos
We make the interns clean everything with Qtips! (Jeez, I wish we had interns now.)
Great video can you show a video on how to change the boot on the steering please. I have a 2015 Polaris ranger crew 900.
Great video!!
Great video. Well done.
Great video! Could have put that front lower a-arm bolt back in from the rear. Might have saved ya some time next time. Lol
Berry nice like everything you do tks for the tips
I don't have a press. Is there a tool to remove ball joint on a 2014 RZR 900 xp without removing A arm?
Have you ever used a manual hand held c-clamp style ball joint press?
Does that go for the basic 800 trail to
Hey man I have a 2012 Rzr 800, I had A LOT of slop/play between the ball joint and the spindle. I’ve ordered replacement parts for both but I cannot find the exact pinch bolt I’m suppose to use. Do you have a part number or the exact size or anything that can help. Any info is appreciated thank you !
Here is the diagram for the front arms. Not sure which bolt you are referring to.
www.partzilla.com/catalog/polaris/side-by-side/2012/rzr-800-efi-eps-r12vh76ab-ad-af-ah-ai-aj-am-eab-eas/suspension-front-control-arms
i am rebuilding a Yamaha tt600 1983 and it has piston slap i measured the bore and its in speck and the piston is too, there is not any bent con rods but the bottom end bearing arnt the best what can i do?
Basic rule of thumb, if you're already in the area, replace the bearings, no reason not to if they "aren't the best."
None of this went near as smooth as it did in this video
Mine aren’t just sliding back into place like that.... PLEASE HELP!!!!!
Are you pressing them in?