thanks for the videos and your time & knowledge my guy. I have to rebuild this for my 05 camry. Just hope it goes well Not familiar with the 2 balance shafts under the crank.
Thanks for the video! I did swap my 2002 Camry's engine. The car hesitates when accelerating (not a smooth RPM acceleration), any idea what's causing this? also the Evap and Cat system is not ready. I drove for 100's of miles with no change.
@@thelthrythquezada8397 I can't remember but I think so. When you remove the old bolts see if they used red or blue then apply the same thing when installing it 👍
Hello, very well explained, I want to know if you can tell me how to calibrate and if you give me the values for each exhaust valve as for intake of this three-cylinder TOYOTA YARIS second series 2° XP9 (2005/2011)
@@ValleyMobileAutomotive thanks much I finally put it in and now the flywheel doesn’t turn bcz my torque converter is not all the way in. I have to take motor out tomorrow. How do I know if torque converter is all the way in pls
Awesomeness
Again “ your videos are the most helpful that I could find on the internet “. Well done. 👏👏👏👏👏👏
Thanks! If you have any questions feel free to post them 👍
Well done. Look at me trying to it all myself!!!!! 😊. So help me God.
i have to aswell good luck to you
thanks for the videos and your time & knowledge my guy. I have to rebuild this for my 05 camry. Just hope it goes well Not familiar with the 2 balance shafts under the crank.
Thanks for the video! I did swap my 2002 Camry's engine. The car hesitates when accelerating (not a smooth RPM acceleration), any idea what's causing this? also the Evap and Cat system is not ready. I drove for 100's of miles with no change.
I have been checking everywhere, where is the EGR on this engine?
Is the flex plate "zero balanced" so it will be okay in any position? Since it's not keyed, a new replacement one would go on in any position too.
Awesomeness
You may not get to my question soon, but I have time. Is the red lock tight the one that you used? (7:05 Mark)
@@thelthrythquezada8397 I can't remember but I think so. When you remove the old bolts see if they used red or blue then apply the same thing when installing it 👍
@@ValleyMobileAutomotive Great point sir, thanks!!! We shall see come this weekend.
@@thelthrythquezada8397 Let us know how it goes 👍
@@ValleyMobileAutomotive Well... I FINALLY got the engine in but I still have to button her up through out the week.
Hello, very well explained, I want to know if you can tell me how to calibrate and if you give me the values for each exhaust valve as for intake of this three-cylinder TOYOTA YARIS second series 2° XP9 (2005/2011)
Did you install power steering pump with hoses on it?
I am having hard time aligning dowel pin from engine to transmission. any tips. still holding on for a day without any luck
Aligning the engine back onto the transmission is a challenge for sure. Putting a jack under the transmission to adjust its tilt can help.
@@ValleyMobileAutomotive thanks much I finally put it in and now the flywheel doesn’t turn bcz my torque converter is not all the way in. I have to take motor out tomorrow. How do I know if torque converter is all the way in pls
WHAT WAS THE TOTAL COST LABOR AND PARTS
Great video, what is the name of that OBD scanner you used ?
Hey thanks! I'm using the Launch X-431
A lot of aftermarket coils are such junk.