2004 procharged Mach 1 mustang.
ฝัง
- เผยแพร่เมื่อ 16 ก.ย. 2024
- This video was recorded sept 27th 2016.
700hp mach 1 for sale.
Termi shortblock. 25k miles
Heads fresh valve job and resurfaced before bolting onto shortblock.
Comp stage 1 blower cams and springs
Procharger D1 16psi
Bbk long tube headers
Hollow cat xpipe
Division x dual pump hat(dual 465s)
2nd pump on 4psi hobbs switch
10an feed line Y block to dual 8an to rails
8an return
Fore fuel rails, fittings, and regulator
Innovative dual bank wideband
Gloshift boost gauge
E85
Wire tucked engine bay
McLeod rxt clutch
Promotion 3650
Mgw shifter
Aluminum drive shaft
3.90 gears
31 spline axles
Welded tubes
Tubular k member
Front upr coilovers
SR Camber caster plates
strange 10 way struts
Poly motor mounts
UPR upper and lower control arms
Strange 10 way rear shocks
Rear GT mustang springs
Procharger has about 10000 miles on it.
Bolted my heads to the block 5000 miles ago. Had made several dyno pulls during tuning and been down the track a few times this past summer. I feel everything has proven out to be reliable and race ready. Car drives like stock around town with the added bit of blower noise and the big red BOV.
your 40th badges are turned around on the fender
happens from the factory mom and step dad had two 04s and one ran forward and the other backwards actually had to call to ford see who's car was made wrong XD
Glws beautiful Mach man
Damn fine Mach. Wish I could buy it saw the post on Ebay.
I have a procharged 04 4.6 what size belt should I run for my procharged doesn’t say for sure just look on forums most ppl say 108 inches and they all use regular cheap belts I noticed you have a green one looks nicer what size is it
man that was a long time ago. i dont remember the belt size. i had done a 8 rib pulley conversion tho and had 10%od crank pulley and i think a 3.5 blower pulley. i think the way i found the belt i needed is i looked on the gates chart of belts starting with the size of my 6 rib. and ordered a few and found one that fit.
Changer cost
for sale still. kcmo here
Travis Miller i stopped trying to sell it bc i had very little interest through the winter. i also made some upgrades over the winter including $2500 worth of drag wheels from weld and champion billet. if u r interested i will still sell it tho. we would be lookin at around 21k with these brand new wheels.
baad2003mach1 I'll keep looking lmao love the car tho!
I'm in STL. I'll trade you my 2003 Mach with Cobra short block making 486 rwhp lol. (P1SC ran out of steam, haven't upgraded yet)
how much?
kansascity.craigslist.org/cto/5788193182.html
@@baad2003mach1 can u help me out? I have a 04 Mach1 and I want to change out the 6 rib to an 8 rib. Where did u buy ur pulley set at and ur cooling set up that runs over the supercharger to both inlets on the head ?