Best video I've seen so far, I gotta install this, for the first time tomorrow and I got butterflies on how to do the corners. Can I send photos to you to look at? Thanks.
I'm not sure if you want it to look that way on a 45 miter. I simply make a 90 degree cut then bend it in on itself so the face of the f (or j-chanel) just has an overlap. (much the same as j-channel on a gable peak). Bonus look would be to take your knife and slice off the inside of the hem for a tighter outside miter. This would be acceptable if the exterior is getting brick as it would be hidden but for a normal outside corner the gap would show.
So.... How many times did you have to hit those nails to drive them in? Seriously, I'm glad I'm not working ouside in these cold months anymore... You Youngsters can have at it ... LMAO
Thanks for the video. Definity helps those who are learning. Keep up the good work friend.
I like it! I will be doing this on my house. Thanks and be careful on those ladder jacks lol
Thanks for the video 👍
Best video I've seen so far, I gotta install this, for the first time tomorrow and I got butterflies on how to do the corners. Can I send photos to you to look at? Thanks.
I'm not sure if you want it to look that way on a 45 miter. I simply make a 90 degree cut then bend it in on itself so the face of the f (or j-chanel) just has an overlap. (much the same as j-channel on a gable peak). Bonus look would be to take your knife and slice off the inside of the hem for a tighter outside miter. This would be acceptable if the exterior is getting brick as it would be hidden but for a normal outside corner the gap would show.
Clean!
-Will
So.... How many times did you have to hit those nails to drive them in? Seriously, I'm glad I'm not working ouside in these cold months anymore... You Youngsters can have at it ... LMAO
Lol I know that was terrible, didn’t want to hit the F again hahahaha
Hammer is way too big for siding and metal work lol.
Not if you know how to use it.
@@buckethead1928 Didn't you hit and break the j channel?
@@Phoenixrising8313 lol I did hit it but it didn’t break. And I seen that after I replied to your comment 😂
Why go down and grab a grinder snips is way faster
Because when it is cold it cracks
Helpful video, but you could set a better example for safety. No guard on your grinder, no eye or ear protection.
You’re right, thanks for the comment!
Real men don't need safety
@@vin4301How would you know? Did you ask one?
The safety sqint and selective hearing are a close second to glasses and ear plugs.
This is not the way to do that
It'd be a great look with the cutout angle reduced so the final gap was closed up. Loved the concept, the guys.