Setup and Demo. of Festool's LR32 system.

I've had quite a few questions and requests on the LR32 system, so i figured to do a complete video on it.
Sorry for the video getting cut short but thank you for all the subscribes, likes and comments.
LR32 system 584100LR $535.00
Festool #496939 55" rail $145.00
Festool 1010 router #574691 $470.00
If you want a Mikes wood shop sticker or have any questions please send it to [e-mail]
I hope you enjoy this video and it answered all your questions.
Thanks Mike

[@jwar2163]

I just purchased the LR32 system with the OF1400 router along with the Domino and the T55 saw system. Thanks for helping me make that decision by actually showing the Festool in use.

[@brianstoolsandgadgets783]

Great video Mike. I enjoy all your videos. I just bought the LR32 and j think I’m going to love it.

[@jronmanbuilds]

Great video. Very informative. I have the LR-32 system but have never used it yet and I have to try and figure it out. This was very helpful in doing so.

[@TheLastPharm]

Pretty good video, Mike, I learned some things here that Sedgetool overlooked in one of his videos on this system; one being the difference in attaching the OF 1010 vs attaching the OF 1400. I have the OF 1400 and attached it using the method for the OF 1010. I never realized what the two machine screws were meant for and Sedgetool missed out on explaining this differs from attaching the 1010.

[@toolnut]

Nice work demonstrating the LR32 system, Mike.

[@MINGLE2008]

Thank you for the demostration.

[@DragonGateDesign]

Awesome work

[@MrSlyguy63]

Hi Mike, nice video. I think that you would put Norm to shame. Hahaha

[@lowellsmith3413]

Nice demo Mike. I love the LR32! You know, the 9.5mm mark on the guide rail stop bar that clamps on the top of the rail for location works real good when building boxes for the SYS Drawers. The instructions for the SYS drawers say the minimum height for the first hole is 8mm. Using the 9.5 mm setting on the location bar gets that first SYS drawer nice and tight to the bottom of the box.

[@bigdogmn73]

Hey Mike - qq on your festool vacuum behind you in this video. What connector did you use to connect your hose to that ODD? That sleeve hose doesn't connect on there right. Thanks, Nate

[@matteason989]

Hey Mike have you ever had the 1010 slip on you off center on the LR-32 plate? It happened to me yesterday.

[@nuzzler6704]

Hi Mike: Enjoyed the video but I have a few questions. I have the LR32 system and the rail and every time I use it for the sys drawer slides I never get it to match the other side holes. I set it sixteen up and out for the left side but when I do the right side holes they never line up with the left side holes. If you set the left side at 58 mms what do you set the right side to? I know you reverse the rail and I think you said the same setting at the top for the right side. That probable was my problem for the right side 16 up and out . Is that correct?

[@donhoward4924]

Mike, is your shop air conditioned.? When did that happen? Is there a video?

[@batesdesignandbuildltd.6529]

"Hey TH-cam"... This is your slogan so I would make up some tshirts and hats and sell them...

[@YIQUANONE]

I think you forgot to tell people the length of board must divide by 32mm evenly, or flipping 16 up and out won't work.

[@konamanstudio2447]

Is that a 40K Aquila on your arm