C5 Corvette Upper Oil Pan Gasket Replacement
ฝัง
- เผยแพร่เมื่อ 14 ต.ค. 2024
- Replacing the upper oil pan gasket on my 2004 c5 corvette
Lower Pan Gasket Replacement:
• C5 Corvette oil change...
Oil Pan Gasket:
www.amazon.com...
ARP Oil Pan Bolts:
www.summitraci...
Engine Support Bar:
www.harborfrei...
Jack Cross Beam:
www.harborfrei...
C5 Corvette Torque Specs:
www.corvette-w...
2004 c5 corvette
Ls1/t56 (manual)
Comp drift cam 54-777-11
Ls6 valve springs
Ls7 clutch
Monster clutch remote bleeder
LT headers
Off road x pipe
SLP loudmouth axle back exhaust
Vararam ram air intake
B&M short shifter
FDF raceshop hydro
Drift HQ dual caliper kit
MSD 2 step
G-stream aero rear wing
Zr1 style front lip
Ligenfelter clutch return spring
Vettelights laser LED taillights
QA1 Coilovers
C6 z06 OE wheels replicas
275/40/17x9.5 front
295/35/18x10.5 rear
Filming Equipment:
iPhone 13 Pro
DJI Osmo Mobile 3 gimbal
GoPro Hero 9
Hotem iSteady pro 4 gimbal
Instagram: @htpjay
/ htpjay
TikTok: @htp_jay
/ htp_jay
Disclaimer: I am not a licensed professional. If you do not feel comfortable doing any of the things featured in this video please contact or seek professional for advice or help.
Jeez, brave soul doing all that and not using a lift and filming whilst doing it! Fair play to you👏🇬🇧
Props to you bro not a fun job. Had to do it while I was replacing cam and damaged lifters and had a surprise melted piston I had to replace via pushing it out from the bottom. I probably did it wrong and am still leaking a little oil either from the front where it meets the timing cover or because I didn’t buy a timing cover alignment tool and it’s ever so slightly off. It’s a small but consistent leak so I’m not worried about it worsening since everything is new.
Put wood on the engine brace at least and use a drill on the rivets and put the oil pan on a rag or some type of soft surface other than that good job👍
Thank you
Mine still leaks in the front corners after replacement. Any ideas why? I put extra silicoln there
Might not be aligned or torqued correctly?
@@HTPJay I torqued it properly to my knowledge. bought an inch pounds torque wrench for the job. After realizing it was still leaking i tried snugging up the corners more. I've just guessed it wasn't aligned properly but idk
Did you rivet the gasket back in place?
No
@@HTPJay thank you. I’m about to do this job and wasn’t sure if it needed it or not
How much hour you do this?
About 6 hours
One very important question is do you know JESUS CHRIST AS YOUR PERSONAL LORD AND SAVIOR?