8th generation Toyota Camry, ambient lighting install.

Fist section took 20 minutes and cup holder took me 30 minutes.
Both were purchased off all the Aliexpress for under 35$
Left center console light
kit a.aliexpress.c...
Cup holder light kit
a.aliexpress.c...

[@terrenceforbes5935]

Thanks for this install vid bud, you made it look super simple, and it is. I know from previous ambient lighting installs. I'm supposed to be getting the cupholder light today so I'm looking to tackle this ASAP. Its funny that youll have the sellers sell these accessories for the Camry and never provide the buyers with installation "how-tos". Thanks again for your vid!!! 😃👍🏽👍🏽

[@nonsenseandcraziness]

I was running into the same problem so I wanted to solve it for other people! trying to figure out how to do wiring can be difficult especially with no directions.
how did your instal go?

[@rynotopdeckryno3726]

This was super helpful Andrew! It looks great, I'll be using this video as a guide to get mine done!

[@osdielns6034]

Excellent. I did install mine already thanks to this video

[@krazziejrboi]

You the man them asian sites arent too clear on install lol

[@jimmunhall]

These pesky wiring clips, what is the trick to separating them from each other. I just press the tab at the top and pull apart correct ?

[@spartanshadow13]

Thank you for showing this!
How are these holding up? Is the color similar or the same as the stock lights from the buttons on the dash? We would really appreciate a video at night. I bet they look awesome.

[@nonsenseandcraziness]

They are the exact same color and are holding up great!

[@alonsojimenez9143]

Hi, where I can buy this lights? Awesome video btw!!

[@robertm5601]

I've seen them on Amazon. I haven't bought them yet but now know how they go I will. There is a light that goes over where your phone sits, hole is already in trim piece

[@randyperalta7104]

can you add that led light at the glove department in a 22 camry se?

[@TRXSH503]

Yes, they are for 8th gen Camry

[@compacheo603]

Did you install the little cubby light ? That shines down on the sliding component?

[@nonsenseandcraziness]

I have not installed it yet but might in the future.

[@leev2463]

that would be a good video, I would watch it, defiantly interested in doing that too ! @@nonsenseandcraziness

[@nonsenseandcraziness]

@@leev2463 fine, fine I’ll order it tomorrow 🙄😂

[@robertm5601]

So you are just stacking the connections?

[@malkinsonmalkinson9305]

How fo i add a third line

[@bigshaq3003]

Did you have to solder any wires for the cup holder light

[@nonsenseandcraziness]

Absolutely not! Just plug and play

[@pimanhappy]

Does this work on a Right-Hand-Drive model too?

[@goldenmanuever1176]

No it does, not. I saw specifically that it is for LHD only.

[@whatitisnt.]

No end result 🤦🏼‍♂️

[@nonsenseandcraziness]

Brother towards the end of the video it shows both installed and tuned on.