RC did not take into consideration a Jeep with manual transmission. The grommet used to fish the wiring harness through the firewall is taken up by the clutch system. Epic fail on the part of RC! Either you have to dig out the battery, tray, fuse box, aux battery and poke a hole through the existing rubber grommet on the passenger side (good luck) or, fish the wiring harness up and behind the gauge cluster, out and through the windshield and its foam insulation, down the cowl, through the hood foam and along the AC plumbing.
Once installed do you have to use the factory wiring provided in light bars and cube lights? Or can you just run a positive and negative wire to it? Factory comes with it's own switch fuse etc?
![Installing the MLC-6 on a Jeep Wrangler JL [by Rough Country]](http://i.ytimg.com/vi/W9Fsl1ARcCY/mqdefault.jpg)
![Installing the MLC-6 on a Jeep Wrangler JL [by Rough Country]](/img/tr.png)
That's exactly what I do is take a bunch of pics if it's to many wires to mark. I've been looking for a switch panel like this, great job and thanks.
RC did not take into consideration a Jeep with manual transmission. The grommet used to fish the wiring harness through the firewall is taken up by the clutch system. Epic fail on the part of RC!
Either you have to dig out the battery, tray, fuse box, aux battery and poke a hole through the existing rubber grommet on the passenger side (good luck) or, fish the wiring harness up and behind the gauge cluster, out and through the windshield and its foam insulation, down the cowl, through the hood foam and along the AC plumbing.
Good information. Thanks for the video.
This is so good I need to install those switches on my JL
Helpful video man! Wanna do a video on how to connect accessories to the MLC-6, would be super helpful!!!
Simple, run them to the box under the hood, easily labeled from there
I was installing my mlc-6 but stopped halfway because I couldn't pop the center bezel off. I'm afraid to break something. It's my first time.
Have you installed this in a 2021 diesel gladiator?
No we have not
Any suggestions?
By any chance do you know if this can power a winch?
No, so not connect your winch to it! Go direct to battery .
@@TheJeepLab awesome thank you.
Once installed do you have to use the factory wiring provided in light bars and cube lights? Or can you just run a positive and negative wire to it? Factory comes with it's own switch fuse etc?
@@mulleysr3605 you can run a positive and negative from the light to the box under the hood.
Nice video but your intro is too long in my opinion.