Ls s10 nv3500 with spintech mufflers sound clips
ฝัง
- เผยแพร่เมื่อ 5 ต.ค. 2024
- 5.3 nv3500 swap s10 with hedman 1 3/4” longtubes 3” dual exhaust into X pipe with 2 spintech 6000 mufflers exiting the rear at equal length
Idle clips and ride along
#lsswap #automobile #btr #truck #s10 #spintech #s10life #ss3 #streetcar #dailydriver #dailyvlog #sound #fun #lsswaptheworld #work #life #speed #chevrolet #minitruck #homemade #diy #cruising #lowrider #lm7 #slow #tradition #burble #hptuners
Awesome videos!!
What flywheel, clutch, and slave cylinder did you use for nv3500??
Flywheel is from a 6.0 Silverado but everything else is from a 99-04 4.8 5spd Silverado
Luk brand clutch and slave but the flywheel was a sachs brand
I would imagine that everything from a 4.8 5spd truck would fit since 4.8/5.3 share the same block
Sounds really nice man. Do you get any popping when you down shift and let off?
@@MrGsxr10001 I have it tuned in to pop and bang a good bit
Bad ass truck 😎
Thanks
I just got a 97 s10 2.2 5speed truck. I will be working on very soon.
What all do I need for a swap, ls 5.3 stock, get the computer and I want the dash to work.
Get the harness if you use the 4l60 trans with it
I got a wiring schematic for 96 s10 and I’m sure it’s close enough that I can tell you what wires go to what gauges
On mine I had to run 2 separate cooling temp sensors because the ls ecu needs 1 and the other goes to the s10 dash but oil psi goes to dash wire and volts gauge reads from the stock s10 positive power bank on driver side fender , fuel gage is left alone if you run stock tank
I've been meaning to ask you what gear ratio you running in the rear end
3.73
Went 4.10 once but it was too low for highway use
What rpm you running at 55
@@lumpyswoodworks I know at 70 I’m at 2800 so around 2000 55mph
What kinda wheels are those?
Old 90s eagle tribals
Cuantas pulgadas son lo rines