So my car stands like this gone to limp mode where the turbo cut out. Once i get tge car cleaned in this manner and fault code is deleted. Does the limp mode light get deleted too.
Yes as soon as the DPF gets cleared properly the car will exit limp mode. It happened to me while driving. I was able to rev 3k rpm for about 20 minutes along a road. Then suddenly limp mode was gone, i was very happy.
@@ORileysAutos so far we have only cleaned detached dpf with washing machine. Tried this method yesterday and IT worked fine. Pretty Happy with The results.
@@HUBONEN if you think about it the engine does exactly the same job once you fill the fluid in and start the engine the cat generates its own pressure to flush it out
@@ORileysAutos allmost but i think its still most effective way to cleane them with machine. Solution gets better in every spot when soakin dpf and blast that with water and high pressure. But like this way allso and now have new service to offer for clients . Have a nice Weekend mate.
i have codes: P242E-00 Exhaust Gas Temperature Sensor 3 Circuit Intermittent P246C-00 Diesel Particulate Filter (DPF) Restriction - Not Regenerable P2463-00 Particulate Filter Soot Accumulation diagnostic report: Calculated Catalyst Temperature Bank 1 900 °C Calculated Catalyst Temperature Bank 2 198 °C Exhaust Gas Temperature Sensor 1 144 °C Exhaust Gas Temperature Sensor 2 900 °C Exhaust Gas Temperature Sensor 3 199 °C DPF Differential Pressure Sensor 0.145 psi DPF Differential Pressure Sensor 0.55 V DPF Soot Accumulation 175 % Distance Since Last DPF Replacement 70 km Distance Since Last DPF Regeneration 75 km HO2S 1 2.00 Lambda HO2S Bank 1 Sensor 1 0.04 V HO2S Bank 1 Sensor 1 2.7 Lambda What does this mean? because the code says that sensor 3 is bad, and the data shows that sensor 2 is bad. By the way, where does antara have sensor 2? If sensor 2 is missing, which sensor should I replace?
Boss ihave Chrysler voucher 2.8 diesel when ido dpf regeneration this car switch of himself after ican diagnos the car show me this fualtcode low fuel pressure p0087
Another satisfactory resolution
I have this car and currently have a DPF light on the dash but didn’t see the same light on the dash of this one, any reason for that?
No answer...what that mean ? Video made only for personal interest...earning from youtube.
So my car stands like this gone to limp mode where the turbo cut out. Once i get tge car cleaned in this manner and fault code is deleted. Does the limp mode light get deleted too.
Yes as soon as the DPF gets cleared properly the car will exit limp mode. It happened to me while driving. I was able to rev 3k rpm for about 20 minutes along a road. Then suddenly limp mode was gone, i was very happy.
How much does this cost pkease
What caused this car to overheat and what is the symptom when it starts to overheat
is this the jtd engine or what
Hi! How often you get that badly blocked dpf that IT cant cleaned with this procedure.
I've had it 2 times In 3 years
@@ORileysAutos so far we have only cleaned detached dpf with washing machine. Tried this method yesterday and IT worked fine. Pretty Happy with The results.
@@HUBONEN if you think about it the engine does exactly the same job once you fill the fluid in and start the engine the cat generates its own pressure to flush it out
@@ORileysAutos allmost but i think its still most effective way to cleane them with machine. Solution gets better in every spot when soakin dpf and blast that with water and high pressure. But like this way allso and now have new service to offer for clients . Have a nice Weekend mate.
I have one of this car but after 5 minute drive it would just cut off what is the cause can someone tell me
i have codes:
P242E-00 Exhaust Gas Temperature Sensor 3 Circuit Intermittent
P246C-00 Diesel Particulate Filter (DPF) Restriction - Not Regenerable
P2463-00 Particulate Filter Soot Accumulation
diagnostic report:
Calculated Catalyst Temperature Bank 1 900 °C
Calculated Catalyst Temperature Bank 2 198 °C
Exhaust Gas Temperature Sensor 1 144 °C
Exhaust Gas Temperature Sensor 2 900 °C
Exhaust Gas Temperature Sensor 3 199 °C
DPF Differential Pressure Sensor 0.145 psi
DPF Differential Pressure Sensor 0.55 V
DPF Soot Accumulation 175 %
Distance Since Last DPF Replacement 70 km
Distance Since Last DPF Regeneration 75 km
HO2S 1 2.00 Lambda
HO2S Bank 1 Sensor 1 0.04 V
HO2S Bank 1 Sensor 1 2.7 Lambda
What does this mean? because the code says that sensor 3 is bad, and the data shows that sensor 2 is bad. By the way, where does antara have sensor 2? If sensor 2 is missing, which sensor should I replace?
Is thst the same engine that’s in the transit. Peugeot diesel/ pity ur not in Ireland
Probably a GM engine ( 2015 opel/vauxall still owned by GM )
I'm not familiar with this engine at all but vauxhall diesels are usually from Fiat.
This engine looked Similar to Japanese engines so not sure on it
@@ORileysAutos I thinks it's as chevrolet captiva ..but not sure GM made the engine themself ..( maybe a Kia engine ? )
Boss ihave Chrysler voucher 2.8 diesel when ido dpf regeneration this car switch of himself after ican diagnos the car show me this fualtcode low fuel pressure p0087
First thing to do with low fuel pressure is change the fuel filter