Great to hear the half a hole trick. I was taught the same thing when I was an apprentice. I rebuilt engines and fuel systems and ran the dyno at Fabick Cat before I went into a field truck. I enjoy getting to work on these older engines in the field.
I had personally never even seen a 3208 until about a month ago. Had to get the veteran to help me out, much better than following a manual on SIS web.
When you see that in a truck it's so small, great fuel mileage, I had worn in a Ford dump truck and it's only really good for flat land, we did a lot of work with that in Phoenix Arizona in the valley, you had a 13 speed Fuller are shift transmission it was awesome.
gr8 vid- i want to make a simple puller, can you give me the bolt thread and hole spacing for the gear? And does the gear get pulled off against the center/shaft or the block? would a small slide hammer work?
Great to hear the half a hole trick. I was taught the same thing when I was an apprentice. I rebuilt engines and fuel systems and ran the dyno at Fabick Cat before I went into a field truck. I enjoy getting to work on these older engines in the field.
I had personally never even seen a 3208 until about a month ago. Had to get the veteran to help me out, much better than following a manual on SIS web.
When you see that in a truck it's so small, great fuel mileage, I had worn in a Ford dump truck and it's only really good for flat land, we did a lot of work with that in Phoenix Arizona in the valley, you had a 13 speed Fuller are shift transmission it was awesome.
gr8 vid- i want to make a simple puller, can you give me the bolt thread and hole spacing for the gear? And does the gear get pulled off against the center/shaft or the block? would a small slide hammer work?
Torque control group under cover. old cat mechanic
Start it up
I need an uninstall video 😅
That engine needs to be under the hood of a nice engine swap ford f-250-550