2013 - 2017 Honda Accord Strut Mount or Strut Replacement, front end noise
ฝัง
- เผยแพร่เมื่อ 24 เม.ย. 2023
- Detail video of how to remove and replace a 2013, 2014, 2015, 2016 & 2017 Honda Accord Strut Mount or Strut Replacement. Front end noise, passenger right side noise or driver left side noise. Rattling sound in front of 2013 - 2017 Honda Accord Strut Mount or Strut Replacement, front end noise
![แขกคนแรกร้านแจ๊ส [ซี - เอมมี่] | iJazzKhunJang](http://i.ytimg.com/vi/XP6C9kulFfc/mqdefault.jpg)
Perfect video,thanks 👌 👍
I'm changing my by morning. Thank you so much. This video was enlightening
Your welcome
Explain everything very well 👍 more vids like this
Thank you
thank you for this post, my dude. very helpful. 💯
Your welcome
Great tutorial!
thanks the best video so far even though you didn't change the strut but is exactly the same thing lol 😂
Thanks for the 411, brother!
No problem
Nice vedio but putting a vice grip on the strut pole is a very bad idea, if you as much as scratch the pole it will cause the seal to leak and secondly, if the strut pole is sliding down inside you pushing up you have a damaged strut. Quick tip. A bent strut pole will damage the mount.
You are right and that's why I did not move it at all or spin it, it was just to hold it.
You make me a little nervous sliding your feet under the car when you only have it up with a floor jack. Never get any of your body bits under a car if it's only supported by a jack and not jack stands...
That's true, i have 4 jack stands and I was just lazy and said it would be quick. It is always best to use jack stand with jacks.
How did you get the bolt for the strut mount not to spin?
Have to use an impach wrench
What’s the tool used to pop the tie rod end out?
Ball joint removal tool, get it on amazon cheap like $20
To do this job properly you have to take the lower ball joint out and separate it from the knuckle and take the axle out of the knuckle. Remove the knuckle from the strut and the strut will come right out . This is not a job you should do on the street. You see he doesn’t show how he got the strut and knuckle lined back up. It was probably him and two other people.😂😂😂
I tried doing it his way and you are right. I had to ask my friend for help and we STILL struggled with 2 people to get the strut back into the knuckle. I will try your way now for the other side. Thank you 7951!
is it difficult to pop the cv axle back in?
No, it is not. It's a tripod bearing that slides in a slot.
I wish you showed that part a little more but ty
@ackeem Smith it did not come out on the booth. So it is show in the vid. Just don't remove the both and you good
How'd you get it back in?
Its in the video
What model/torque is that Rigid?
Model # R86212B-AC87004
Yang sebelah kiri bagaimana cara bukanya,apa sama seperti sebelah kanan Mr mekanik
It’s same procedure.
Hope you bleed the brakes after doing this. Because taking the banjo boat off. You let a lot of air in the system.
Ha. Rookie
Dang good video!
Thank you