How To Install Adjustable Rear Camber Arms Infiniti G35 + (DIY alignment Guide)

Today we are showing you how to install Voodo 13 adjustable rear camber arms on our Infiniti G35 Coupe plus a DIY alignment Guide. This car has the same setup at the Nissan 350z.
Link to Voodo13 Control Arms
voodoo13usa.co...

[@koachs77]

The one on the spring bucket is for toe , the one your do’in is camber , but , there is another arm go’in forward which does affect the alinement , i know

[@koachs77]

The adjustment plate you used are not needed if you those adjustable arms , just on the spring bucket , +/- .5 lockouts , on the voodoo’s use a centered lockout

[@koachs77]

You dhould have bought lockout plates , for both of them , spring bucket you could use an offset lockout .5 +/-

[@lionsinmar6401]

A little positive camber is good though. As the car dips on acceleration, your camber moves towards negative degrees

[@OctaneMonkey]

A little positie camber would be fine for a road car. Its true that the car will gain negative camber as it squats.

[@jesusc7918]

So I lowered my car on coil overs and went to get an alignment after and said they couldn’t do the rear since the rear camber was out of specs do will camber arms fix the issue?

[@bloodyrose9568]

Yeah bro control arms will fix it they told me same thing and I talked to them and they just send it’ll need the adjustable control arms

[@12345nidal]

Just to confirm, drilling is only needed for the eccentric elimination bolts (where a toe arm can be put on for coilovers)?

[@OctaneMonkey]

That is correct

[@danigarcia1788]

Thanks for the video. any link for the camber bolts?

[@jordanchristensen5715]

Does elongating the hole where the bolts go cause any problems in the future or potentially dangerous to drive? Been thinking of doing the same to my m35

[@OctaneMonkey]

Not unless they are extreme i.e. there is no metal left on the bracket. 😉

[@user-wz6bp9uz6s]

@@OctaneMonkey would these work on a sedan 2007 35 ?

[@OctaneMonkey]

@@user-wz6bp9uz6s yes, sedan and coupe are the same

[@kingcal2427]

👌✌thanks

[@raysb240sx]

What size drill bit did you use?

[@OctaneMonkey]

I believe it was 3/8.

[@kelszgarcia8645]

Do you think this fit fx35 2004 to add more camber ?

[@OctaneMonkey]

It should be the same design, but I think the arms are slighty shorter.

[@immortal2393]

Hey how are these holding up ?

[@OctaneMonkey]

Sold the car, but I had zero issues with them. I have installed a number of differnet brand camber arms on a number of vehicles and these voodoo ones are well manufactured, and really good quality for the price.

[@vqjohnny8207]

Where can I get that template!

[@OctaneMonkey]

It came with bolts

[@vqjohnny8207]

@@OctaneMonkey thank you🙏🏼

[@vqjohnny8207]

@@OctaneMonkey do you need to install those bolts and elongate the hole to add more negative camber?