Nissan Micra K12 Wiper Motor Linkage Repair Replacement Push Rod Set Instruction Guide Install

Link to purchase product: x8r.co.uk/repair-replacement-...
Symptoms of the fault
The symptoms of this fault are very obvious; windscreen wipers simply not working, there's only one windscreen wiper working or the windscreen wiper movement is erratic or juddering with the wiper link popping off frequently.
The cause
The original soft plastic bush bearings on each end of the two wiper linkage push rods wear down leading to the push rods popping off of their respective ball joint. Dependent on which rod pops off or if the rods haven't popped of but there is excess movement in the joint this will cause the symptoms noted above. It is a very common fault on this model. Until now it has only been possible to buy a whole new wiper mechanism at vast cost which would just fail again
The solution
Our high quality new rods simply replace the original worn out rods; this is a very simple process, with full instructions included. Save the cost of a complete replacement mechanism that would just fail again. Our rods are fitted with upgraded high quality plastic bearings giving a smoother and more reliable wipe, a vast improvement over the OEM part, designed to last the life of the vehicle not the life of the vehicles warranty.
Vehicles affected
Nissan Micra K12 2003-2010 all models.
Right Hand Drive only
Part numbers:
28840AX60A
Available exclusively from X8R Ltd
www.x8r.co.uk

[@davidhandley9007]

Great video, pain in the back side when these go!

[@rosalindduckworth7702]

Very good video thank you

[@trendingproducts990]

Very clear nice video. Thank you.

[@ijazhussain7127]

What amazing video. Well done

[@lukaszagaiga]

Very helpfully thanks

[@stea189]

Good video ,wanted to find way of getting stuck wipers off,rubbermallet ,should of figured that!.

[@Colin623]

Good video, but you should of put some grease on the ball joints !!