How to Replace Front Lower Control Arm Bushing 2008-2012 Honda Accord

Buy Now!
New Control Arm Bushing from 1AAuto.com 1aau.to/ib/1ASMX00386
This video shows you how to install a front lower control arm bushing on your 2008-2012 Honda Accord. Rubber bushings help smooth out a ride, but are susceptible to wear or drying out and crumbling over time. This bushing is replaceable separate from the control arm, and you can replace it yourself.
This process should be similar on the following vehicles:
2008 Honda Accord
2009 Honda Accord
2010 Honda Accord
2011 Honda Accord
2012 Honda Accord
Tools you will need:
• Pry Bar 1aau.to/oa/1AXAA00020
• 15mm Wrench 1aau.to/oa/1AXAA00010
• 17mm Wrench 1aau.to/oa/1AXAA00010
• 17mm Socket 1aau.to/oa/1AXAA00015
• 19mm Socket 1aau.to/oa/1AXAA00043
• Pliers
• Air Chisel 1aau.to/oa/1AXAA00270
• Ratchet 1aau.to/oa/1AXAA00016
• Torque Wrench 1aau.to/oa/1AXAA00044
• Brake Grease
• Jack Stands 1aau.to/oa/1AXAA00065
• Rubber Mallet 1aau.to/oa/1AXAA00413
• Vise
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@ItsAlive111]

Thanks for the video but it's weird that you only changed that small rear bushing instead of the bigger one in the front that is most likely to start cracking. Or just replace all 3 of them at that point.

[@yohkodevilhunter8292]

What tool (cap) was it you used to drive the bushing in?

[@Brincandopabajo]

That is not easy.