Can't stop watching this build, I haven't checked but I hope to see the finished project and I'm pleased to see you tidied up the bench before you started the tank sealer. Great viewing.
It turned out far better than I expected it would. I do have a really nice Mac punch set but I hardly use them because it's a nice set. Need to make a punch? Hf to the grinder it is. Need a pry bar? Hf punch set it is. Lol
Can't stop watching this build, I haven't checked but I hope to see the finished project and I'm pleased to see you tidied up the bench before you started the tank sealer. Great viewing.
Very rarely but sometimes if the mood strikes, I will clean off the bench. Well I'll clean off a spot big enough to do whatever I'm working on. Maybe
Reality pops up quickly, good work and thanks for sharing.
4:25 I thought you used dimple dies. That dimple came out real nice. I swear every person on the planet has those green HF punch sets. Haha
It turned out far better than I expected it would.
I do have a really nice Mac punch set but I hardly use them because it's a nice set. Need to make a punch? Hf to the grinder it is. Need a pry bar? Hf punch set it is. Lol
nice! What gauge steel are those tanks usually?
Oh idk. They're not super stout. Maybe 16?
Could you tell me where you purchased the tank? It fits well and I’m in the middle of the same project. Thank you.
eBay cafe racer tank. It took frame mods and tank mods to make that one work, but it did look good.
What wire gauge are you welding with ?
035 shield gas 75 25 CO2 argon