C4 Picasso BSI reset due to "Check indicator direction" "Check sidelights"

แชร์
ฝัง
  • เผยแพร่เมื่อ 11 ธ.ค. 2024

ความคิดเห็น • 25

  • @MarcGibson-i8d
    @MarcGibson-i8d 2 หลายเดือนก่อน

    Great video thanks for sharing, dealer wanted to charge me £300 to resolve whilst the car was in the garage, as they had disconnected the battery! Thanks for helping.

  • @AmbroseB1900
    @AmbroseB1900 2 ปีที่แล้ว +2

    Very useful video. Great info to share. Thnx.

  • @jeff.71
    @jeff.71 8 หลายเดือนก่อน +1

    Thank you for the video! Amazing information! I had to do it twice, but on the third time I did it correctly.😉👍

  • @KK11AN
    @KK11AN 9 หลายเดือนก่อน +3

    The 'hold remote close button for 10 seconds' - is that with ignition on or off? Bearing in mind the car is keyless, so you need to put the key in? I'm also assuming when you took the key out and tested the remote, the ignition was off?

  • @ih8hertz1
    @ih8hertz1 2 หลายเดือนก่อน +1

    I have ..U1218 BSI clearing of the high frequency control reawakening fault... will this procedure fix that?

  • @billhotham610
    @billhotham610 ปีที่แล้ว

    Thank you, it worked OK for me, but took a couple of times for me too, but got there eventually 😂👍🏻😉

  • @bazzhome810
    @bazzhome810 9 หลายเดือนก่อน

    Thanks it worked first time😜

  • @rlr5525
    @rlr5525 ปีที่แล้ว +1

    Thank you, it worked for me 😁

  • @netanel1014
    @netanel1014 ปีที่แล้ว +2

    Thank you. Iths work!

  • @littlem423
    @littlem423 ปีที่แล้ว

    Step 9 : I can't turn ON ignition without key inserted in key reader, I tried but message on display say No key recognize.

  • @scotthudson21
    @scotthudson21 ปีที่แล้ว

    Great easy to follow video, do you think a BSI reset would fix my problem below
    im having an issue with my citroen C4 1.6 diesel hatchabck 65 plate, when i turn the key to the on poistion the display shows the "electical circuit failure:have the vehicle rapired" warning, and beeps 3 times the service light also appears on the dash. The car starts and drives fine. I tried to check battery volts yesterday but volt meter was playing up, so i just disconnected the positive terminal, left it for a min or two and reconnected, warning went away and i reset the service light by holding the mileage counter down method. Then i starated the car, everything looked good. Turned it off and started it another two times, all fine. I then locked the car and went in for tea, came out aboutan hour later put keys in turned them to the set position before starting engine, warning came back as did the service light.

    • @FXHUBBULGARIA
      @FXHUBBULGARIA ปีที่แล้ว

      This sounds similar to my problem, did you sort it out now, and if yes- how ? ta

  • @simontompkins9417
    @simontompkins9417 ปีที่แล้ว

    Will doing this get the bumper indicators working again. I got towed due to a spark plug issue and as soon as i got it back i have had this warning up. Checked the bulbs all fine they just dont work but all my other hazards do

    • @andrewlumb814
      @andrewlumb814 ปีที่แล้ว

      Bumper indicators at the back? They only operate when the boot is open.

    • @simontompkins9417
      @simontompkins9417 ปีที่แล้ว

      @@andrewlumb814 they don't work even when boot is open. I now been told it could be because the RAC discounted my battery

    • @ih8hertz1
      @ih8hertz1 2 หลายเดือนก่อน

      My doors have started locking after a few minutes😅

    • @critiqueq3086
      @critiqueq3086 8 วันที่ผ่านมา

      @@andrewlumb814 OLDUMU

    • @critiqueq3086
      @critiqueq3086 8 วันที่ผ่านมา

      YAPABİLDİNMİ

  • @autodiyfix7462
    @autodiyfix7462 2 ปีที่แล้ว

    Hi, how to contact you for test a car obd2 scanner?

    • @TheDrivewayExperiment
      @TheDrivewayExperiment  2 ปีที่แล้ว

      Send me an email mate

    • @autodiyfix7462
      @autodiyfix7462 2 ปีที่แล้ว

      @@TheDrivewayExperiment You channel have not give email info

    • @TheDrivewayExperiment
      @TheDrivewayExperiment  2 ปีที่แล้ว

      @@autodiyfix7462 thedrivewayexperiment@gmail.com

    • @scotplanespotter2702
      @scotplanespotter2702 ปีที่แล้ว +1

      Changed the battery on my Citroen C4 2015 grand Picasso and it’s sent everything haywire. Will try this procedure.

    • @WestGhirl
      @WestGhirl ปีที่แล้ว

      Great video! New battery on mine but don’t have an “off” switch on my lights, only on or auto. Might try a BSI reset as some systems not working after new battery put in!

  • @Jesus-bc1cs
    @Jesus-bc1cs ปีที่แล้ว

    Me llamarán progreso😊