@@WaldensWorldoh thanks. No I didn’t get it yet, it’s just been sitting in my garage for a couple weeks, lol. Thanks I’ll have to try that pick technique!
Numera has a complete kit a lot depends on if it’s mine or someone else n there cheap or want it to last lol ! I’ve reused gaskets but I also use gray permetex or copper coat on metal ones ! EBay has good enough kits ! Some grooves are oil passages you can check partzilla.com n it has blown up diagrams of what should be there to be safe ! I get machine missing parts I never worked on before so sometimes it’s needed !
What brand of head gasket do you use. And are the little grooves in the jug for o rings bellow the head gasket? 22:24
What brand of head gasket do you use. And are the little grooves in the jug for o rings bellow the head gasket?
Is this the same motor that’s in a 2018 Kawasaki brute force 300
Check partzilla. Com at the bottom it give a list of all models that are comparable I use it a lot for parts
What can I do, my 2001 kawasaki prairie 300 4x4 only stays on with the throttle on, any recommendations
Adjust your idle screw
how do you remove the rocker arms? i know you take that philips screw out but don't know how to slide out those pins?
Did you get it yet ? I’m sorry just seen this many rocker arm shaft have threads inside or I use a pic n put in n catch at angle n pull them out !
@@WaldensWorldoh thanks. No I didn’t get it yet, it’s just been sitting in my garage for a couple weeks, lol. Thanks I’ll have to try that pick technique!
What brand of head gasket do you use. And are the little grooves in the jug for o rings bellow the head gasket? 22:24
What brand of head gasket do you use. And are the little grooves in the jug for o rings bellow the head gasket?
Numera has a complete kit a lot depends on if it’s mine or someone else n there cheap or want it to last lol ! I’ve reused gaskets but I also use gray permetex or copper coat on metal ones ! EBay has good enough kits ! Some grooves are oil passages you can check partzilla.com n it has blown up diagrams of what should be there to be safe ! I get machine missing parts I never worked on before so sometimes it’s needed !