Diagnosing my KJET cold start problem
ฝัง
- เผยแพร่เมื่อ 28 ส.ค. 2024
- In this video I share how I tried to narrow down my cold start problem on my 1977 Volvo 242 with the KJET/CIS fuel system. I'll discuss a little on the relationship between the control pressure regulator (aka the warm up regulator) and the fuel distributor, also I'll show how to use and read a KJET fuel pressure testing gauge, a must have tool when owning a KJET powered car. Subscribe for more videos on my old 240s
Also you can find me on the gram:
/ 240rescue
The internet definitely needs more KJet troubleshooting videos. Thanks for the video!
Thanks for watching! More to come
We all do! Hope your 242 Turbo fired up right away. I hope same happened with my 264 :
I've been daily driving a K-Jet Volvo 240 since 2010 🥰
Word
we need more volvo kjet fixing!!, thanks for your effort
I've been trying to diagnose my cold start issues on my '86 245 wagon, and running into a wall for the past few months. Looking forward to running some tests on it once I get the time! Thanks for the perfectly timed topical upload!
Just break it down by systems, wide scope to narrow and you’ll find the problem or in most cases, multiple problems
Very interesting..i don.t have the tools neither i am not capable to fix it but now i know where is my 740 gle problems has cold starting to tell to the mechanic
Invaluable!
Love the Virgo t-shirt, where d'you get it from?
I know I am a bit late to the party but I have a fuel and ECU related problem. Not on KJET but on LH-JET 2.4 from an Volvo 740 1991. B200F engine. The engine runs fine. But at startup it stalls no matter if the engine is cold or hot. You crank it, it revs up for 1 second as usual but then it stalls. First thaugt was a faulty pump or relay or something related to this. But if you give it a bit of pedal it keeps running, and after 4-6 seconds you can let go the pedal and it runs completely fine. Code on #6 1-1-1 all good. Code on #2 1-2-1 Air mass meter. All connectors even the ground connection and the harness connectors have been cleaned and checked. Code cleared, gives 1-1-1, so next try to start. When you start it normally It either stalls again or the CE Light stays on, and it runs at very low idle. If I just shortly press the pedal to rev it the CE light goes out but the idle is still crap. But the funny thing is: If you clear the code 1-2-1 again, and start it up with the pedal slightly pressed while cranking it, it revs the light goes out instantly and after 5 seconds and release the pedal the idle is normal and you can drive it normaly. Even after some attempts 1-1-1 came back and everything is okay when you press the pedal on startup and hold it slightly for this short period of time. But as soon as you start it without pedal 1-2-1 came back and it either stalls or runs rough and slow at idle. And as I said. The CE light stays on after startup until you first rev the engine.
Thaks a lot mate you tell me the key on my volvo 740 gle,starting problens
Some time happens or not in warm weather too,so i need to Pushkin the gas pedal several time to make the motor starts and need to hold the gas a little as the engine is hot..then its fine
Which pressure gauge are you using?
Hard to say, I found this one in the trunk, but based on the pressure relief, it looks like maybe the S&G Tool Aid one