Mercedes Benz CLA Rear Brake Pads Removal
ฝัง
- เผยแพร่เมื่อ 4 ต.ค. 2024
- This is how I removed the Mercedes Benz CLA rear pads only, it was simple, but pay attention to your work, and please work on your own risk, this is only for entertainment purposes only.
Thank you for the part about programming. You’re re the only person I’ve found that explains how to do it.
There's another video; clearer too.
This was awesome Car-lo. Thank you. I realized later that I had not listened to you properly but I wanted to say that after taking the two bolts out I could not take the caliper off. It finally dawned on me that the CLA has an electronic parking brake (which I am not used to as this wasn't my car) that has to be released. Once that was released the caliper came off and I followed along to the rest of your video. Thank you again!
Awesome, keep up the good work, My mechanic told me the same thing, the inside brake pad is worn more than the outside..
🙏
Nice work!
Thanks brotha!
Please make a video on how to bleed the fluid
My cla has a sensor on the front right side. Rear, I don't see a sensor?
I believe there is no sensor in the rear. Someone correct me if im wrong.
Do u have to take the hand brake off before doing the retract back of the piston
Hi!
04:53 until the end.
@@car-lo I did the pads replacement today thanks for the video would have just liked to know about releasing the handbrake before doing the retract at the beginning of the video but it’s all good thankyou brother
Yes sir, release it, do not engaged the brake.
Hi, will be the same for cla 180 ?
Same :)
@@car-lo thanks 👊
Vážně? Že to servisní menu nevyskočí, jen mazání denního počítadla, tak co s tím??
Hi. Do you need to remove both sides calipers and then move to maintenance mode or can do one side at the time?
Hi,
This procedure only apply to the rear because of the electronic brake aka ebrake- front is normal no procedure.
About to change mine out, front and back. Do you only do the programming for the rear ?
Yes, only for the rear because of the electric parking brakes.
@@car-lo thank you!
@@car-lo one more question. Do you know the amount of torque lbs should be on the caliper bolts?
Thanks!
Values might be calliper frame to knuckle 130-Nm, slider bolt 29-Nm, around there possibly?
👍
Do you do the other side before the same way or you exit out after you have done both sides?
Exit out when you finish both sides.
Caliper assembly was binding and not moving as it should when braking.
Check the pistons make sure that moves freely and test the electronic motor that puts it to park make sure it engage and this engage.
Servisní menu call+ok nefunguje cla 180.