Thanks for the work you put into this. Much appreciated. May I give some feedback. I really couldn't use your guide as with no commentary, each time you selected something with a switch, I would have to stop the video to do it on mine. Then start video, watch next selection by you, then stop video to do it on mine. If at any stage I didn't stop the video and tried to do a switch selection or a programming, you would run ahead of me on the screen. It needs to be slowed down and have voice instructions. Thanks
Hi, please tell me i have a trex 600 nitro heli the problem is that is if the throtle full down the engine turn off , how can i fix this on the full down throtle the engine is start on low rpm how can i do this
Its very simple You can adjust the "Throttle curve" settings under the "Functions setup" Menu. Inside the throttle curve settings, you will find a setting as "L -> 0%". Increase this value till the engine remains running on low throttle. Hope it works.
@@aliasfen The company says that the maximum range is about 1 km. But in real case scenario, its generally less. But if you think that the range is less, then you can check the transmitter and see if the antenna inside is damaged or not.
@@aliasfen The signal can be weak due to some of these reasons:- 1. The transmitter battery voltage is low. 2. The transmitter battery itself is not good quality. 3. The antenna might have become faulty. You can try changing the antenna with a new one. Just buy an ipex to sma antenna connector. You can get that for about 1 dollar.
Good Tutorial
Thanks
Thanks for the work you put into this. Much appreciated. May I give some feedback. I really couldn't use your guide as with no commentary, each time you selected something with a switch, I would have to stop the video to do it on mine. Then start video, watch next selection by you, then stop video to do it on mine. If at any stage I didn't stop the video and tried to do a switch selection or a programming, you would run ahead of me on the screen. It needs to be slowed down and have voice instructions. Thanks
Thanks for the feedback.
I might use voice over in the coming future tutorial videos
A pleasure. A guide like yours is needed as even the long version PDF manual is severely lacking. Thanks again
Hi, please tell me i have a trex 600 nitro heli the problem is that is if the throtle full down the engine turn off , how can i fix this on the full down throtle the engine is start on low rpm how can i do this
Its very simple
You can adjust the "Throttle curve" settings under the "Functions setup" Menu. Inside the throttle curve settings, you will find a setting as "L -> 0%". Increase this value till the engine remains running on low throttle.
Hope it works.
Also, after calibrating the "L", i.e, Low settings, adjust other settings below it too until the throttle graph becomes a straight line.
I have this radio and have range issuie,it is around 200 metters,I also have fsi6 and it has 400 metters range ,i use them on rc boats
@@aliasfen
The company says that the maximum range is about 1 km. But in real case scenario, its generally less.
But if you think that the range is less, then you can check the transmitter and see if the antenna inside is damaged or not.
Both antenas inside are connected and working ,i guess the signal is weak...anyway I am disappointed,I received less for more money
@@aliasfen
The signal can be weak due to some of these reasons:-
1. The transmitter battery voltage is low.
2. The transmitter battery itself is not good quality.
3. The antenna might have become faulty. You can try changing the antenna with a new one. Just buy an ipex to sma antenna connector. You can get that for about 1 dollar.
how to SET batterie level of tx alarm (menue RX battery make nothing)
Its preset. This setting cannot be changed I think