Is your Tein Flex Z or Endura Pro Plus Clicker stuck??? This might be a quick fix. Check it out!!!
ฝัง
- เผยแพร่เมื่อ 8 ก.ค. 2024
- Here's a short video to help those of you that might have brand new shocks or coilovers from Tein and they don't have all the clicks they should. Some are just stuck and some don't get the full number of clicks you want. Well here's how it works and a quick service to see if you can get them to move freely so you don't have to submit a warranty claim. Your friends at ZEVcentric!!!!!
For all your Tein products for Tesla:
zevcentric.com/search?sort_by...
Please become a member!!!!
/ zevcentric - ยานยนต์และพาหนะ
Just ALL AROUND QUALITY INFO!!! Well done again ZEVcentric!!!
Aloha🌴
Thank you
That’s cool stuff, thank you.
Good stuff to know.
Just wondering how you tork to 25Nm the 14mm nut once you put the OE top hat.
In the rear you just hold the shock shaft with your hand so it doesn’t spin while you torque the nut. 25nm is like 18 ft-lbs. its light.
I’ve got a set of Skunk2 coilovers with a similar adjuster setup. But instead of a set screw below the “clicker assembly”, it’s like a little 1-2” long rod with a hex head (looks like a set screw from the top) that was threaded in. I was able to thread it back and fourth but not all the way out, then I backed it out too far on one of the shocks, thinking it would come out the same as the set screw you show. Now it won’t thread back in, or come out. It’s just kind of free in there, and I can’t put the clicker assembly back in. Any suggestions?
contact skunk 2 please
@@zevcentric Thanks for the reply. I have contacted them, they replied but avoided answering the question.
Know where could I get that mini wrench or what's the size please?
Also like to know what size for the wrench!
Nvm found it says 8mm on teinusa
First